[PATCH v2 0/3] pwm support for Broadcom iProc SoC's
Yendapally Reddy Dhananjaya Reddy
yendapally.reddy at broadcom.com
Fri May 20 11:05:49 PDT 2016
This patchset contains the pwm support for the Broadcom's iProc SoC's.
The first patch provides the documentation details and the
second patch contains the controller support details. The third patch
contains the enable method for Northstar Plus SoC.
This patch series has been tested on NSP bcm958625HR board.
The pwm is not enabled for this board as the pins are open and not used.
This patch series is based on v4.6.0-rc1 and is available from github
Changes since v1
Addressed the review comments from Thierry
1. Use separate driver for iProc SoC's.
2. Added Robs ack to the Documentation patch
Yendapally Reddy Dhananjaya Reddy (3):
Documentation: dt: Add Broadcom iproc pwm controller binding
pwm: iproc: Add support for Broadcom iproc pwm controller
ARM: dts: NSP: Add PWM Support to DT
.../devicetree/bindings/pwm/brcm,iproc-pwm.txt | 21 ++
arch/arm/boot/dts/bcm-nsp.dtsi | 8 +
drivers/pwm/Kconfig | 10 +
drivers/pwm/Makefile | 1 +
drivers/pwm/pwm-bcm-iproc.c | 320 +++++++++++++++++++++
5 files changed, 360 insertions(+)
create mode 100644 Documentation/devicetree/bindings/pwm/brcm,iproc-pwm.txt
create mode 100644 drivers/pwm/pwm-bcm-iproc.c
More information about the linux-arm-kernel