[PATCH v2 4/4] documentation: Add secure monitor binding documentation

[Rob Herring]

On Wed, May 18, 2016 at 04:56:22PM +0200, Carlo Caione wrote:
> From: Carlo Caione <carlo at endlessm.com>
> 
> Add the binding documentation for the Amlogic secure monitor driver.
> 
> Signed-off-by: Carlo Caione <carlo at endlessm.com>
> ---
>  .../devicetree/bindings/soc/meson/meson_sm.txt     | 45 ++++++++++++++++++++++
>  1 file changed, 45 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/soc/meson/meson_sm.txt
> 
> diff --git a/Documentation/devicetree/bindings/soc/meson/meson_sm.txt b/Documentation/devicetree/bindings/soc/meson/meson_sm.txt
> new file mode 100644
> index 0000000..f59c732
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/soc/meson/meson_sm.txt

bindings/firmware/

> @@ -0,0 +1,45 @@
> +* Amlogic Secure Monitor
> +
> +In the Amlogic SoCs the Secure Monitor code is used to provide access to the
> +NVMEM, enable JTAG, set USB boot, etc...
> +
> +Required properties for the secure monitor node:
> +- compatible: Should be "amlogic,meson-sm"
> +- amlogic,sm_cmd_input_base: SMC32 function identifier to read the physical
> +                             address of the input buffer
> +- amlogic,sm_cmd_output_base: SMC32 function identifier to read the physical
> +                              address of the output buffer

Use '-' rather than '_'.

> +
> +Example:
> +
> +	#include <dt-bindings/soc/meson-gxbb-sm.h>
> +
> +	...
> +
> +	sm {

Put this under a /firmware node.

> +		compatible = "amlogic,meson-sm";
> +		amlogic,sm_cmd_input_base = <SM_GET_SHARE_MEM_INPUT_BASE>;
> +		amlogic,sm_cmd_output_base = <SM_GET_SHARE_MEM_OUTPUT_BASE>;
> +	};
> +
> +Node of a device using the secure monitor must have a custom property to
> +specify the SMC32 function the driver is going to use. The values of all the
> +SMC function identifiers are listed in a SoC-specific header file:
> +
> +"include/dt-bindings/soc/meson-gxbb-sm.h" - for the Meson GXBB secure monitor.
> +
> +Example of the node using the secure monitor:
> +
> +	#include <dt-bindings/soc/meson-gxbb-sm.h>
> +
> +	...
> +
> +	efuse: efuse {
> +		compatible = "amlogic,meson-gxbb-efuse";
> +		amlogic,sm_cmd_read_efuse = <SM_EFUSE_READ>;
> +		#address-cells = <1>;
> +		#size-cells = <1>;
> +
> +		...
> +	};
> +
> -- 
> 2.7.4
>