[PATCH] usb: echi-hcd: Add register access check in shutdown

[Alan Stern]

On Wed, 18 May 2016, Srinivas Kandagatla wrote:

> This patch adds a check in ehci_shutdown(), to make sure
> that the register access is available before accessing registers.
> 
> The use case is simple, for boards like DB410c where the usb host
> or device functionality is decided based on the micro-usb cable
> presence. If the board boots up with micro-usb connected and the
> host driver is probed, but the ehci_setup() has not been done yet,
> then a system shutdown would trigger below NULL pointer exception
> without this patch.

How can that happen?  While the host driver is probed, the probing
thread holds the device lock.  But the system shutdown routine acquires
the device lock before invoking the ->shutdown callback.  Therefore the 
two things cannot happen concurrently.

> Unable to handle kernel NULL pointer dereference at virtual address
> 00000008

...

> --- a/drivers/usb/host/ehci-hcd.c
> +++ b/drivers/usb/host/ehci-hcd.c
> @@ -368,6 +368,9 @@ static void ehci_shutdown(struct usb_hcd *hcd)
>  {
>  	struct ehci_hcd	*ehci = hcd_to_ehci(hcd);
>  
> +	if (!HCD_HW_ACCESSIBLE(hcd))
> +		return;
> +
>  	spin_lock_irq(&ehci->lock);
>  	ehci->shutdown = true;
>  	ehci->rh_state = EHCI_RH_STOPPING;

This doesn't seem like the right place.  What you really should do is
skip calling ehci_silence_controller() if the hardware isn't
accessible.  That's where the hardware gets touched, not in
ehci_shutdown().

Alan Stern