[PATCH] arm64: dts: r8a7795: Increase the size of GIC-400 mapped registers

[Simon Horman]

Hi Dirk,

On Tue, May 03, 2016 at 07:48:32PM +0200, Dirk Behme wrote:
> Hi Simon,
> 
> On 29.04.2016 12:35, Marc Zyngier wrote:
> >On Fri, 29 Apr 2016 09:43:45 +1000
> >Simon Horman <horms at verge.net.au> wrote:
> >
> >>[Cc Mark Zyngier, linux-arm-kernel]
> >>
> >>Hi Dirk,
> >>
> >>On Thu, Apr 28, 2016 at 07:41:57AM +0200, Dirk Behme wrote:
> >>>Hi Simon,
> >>>
> >>>On 28.04.2016 01:30, Simon Horman wrote:
> >>>>Hi Dirk,
> >>>>
> >>>>I understand that there is an issue here but I'm not yet able
> >>>>to convince myself that this is the correct solution.
> >>>>
> >>>>In revision r0p1 of the CoreLink GIC-400 Generic Interrupt Controller
> >>>>Technical Reference Manual[1] I see in Section 3.2. "GIC-400 register map"
> >>>>that the size of both the CPU interfaces and Virtual CPU interfaces are
> >>>>0x2000 bytes. And assuming that the hardware follows the specification it
> >>>>appears that DT is correctly describing the hardware.
> >>>
> >>>
> >>>I think you are missing the details described by ARM in
> >>>
> >>>http://xenbits.xen.org/gitweb/?p=xen.git;a=commit;h=21550029f709072aacf3b9
> >>>
> >>>
> >>>Maybe Julien could help if you have some more doubts?
> >>
> >>I guess I am confused.
> >>
> >>I see that there is now handling of the case where the region size is
> >>128Kbytes. But I'm still not seeing the bit which describes that the
> >>GIC-400  has a region size of 128Kbytes. Perhaps the later is somehow
> >>implied by the former. Or perhaps I need to check with the hw team.
> >
> >Please have a look at the SBSA document, and in particular the
> >Appendix-F (registration and selling your soul required - only kidding):
> >
> >http://infocenter.arm.com/help/index.jsp?topic=/com.arm.doc.den0029/index.html
> >
> >This requires that, in order for the two halves of GICV to be trappable
> >*separately* by a hypervisor using 64kB pages at Stage-2, the two 4kB
> >pages that describe that region are aliased as such:
> >- the first 4kB page is aliased 16 times over a 64kB region
> >- the second 4kB page is aliased 16 times over another contiguous 64kB
> >   region
> >
> >This means that your GIC is indeed covering a 128kB region, with the
> >mapping corresponding to the GICv2 memory map located at offset 0xf000
> >from the base of that 128kB region. Also, this GICV requirement also
> >applies to GICC (most likely because the two regions use the same
> >decoding logic).
> >
> >The OS must of course be aware of this (see gic_check_eoimode in the
> >GIC driver). Of course, almost nobody got that right (I only know of
> >the APM Xgene-1 so far). If you actually did, great!
> >
> >Also, the ACPI spec fails to recognize this by not providing the length
> >of the region, meaning that those who got it right with DT are likely
> >to get it wrong with ACPI, and vice-versa.
> >
> >It's a wonderful world.
> 
> 
> Could this patch be applied, then?

Yes I have now done so :)