[PATCH 0/4] add minimal bcm2835-sdram driver
kernel at martin.sperl.org
Thu May 12 08:28:57 PDT 2016
> On 12.05.2016, at 16:50, Stefan Wahren <stefan.wahren at i2se.com> wrote:
> Hi Martin,
>> kernel at martin.sperl.org hat am 12. Mai 2016 um 14:38 geschrieben:
>> From: Martin Sperl <kernel at martin.sperl.org>
>> As the sdram clock is a critical clock to the system
>> the minimal bcm2835-sdram driver claims (and enables)
>> this clock and also exposes the corresponding sdram
>> registers via debugfs.
> sounds like this driver should fix an clock handling issue. Unfortunately this
> isn't a solution in case the driver is disabled.
Unfortunately there is no way around this - the driver has
to be enabled so that the sdram clock or the parent pll,
which typically is plld_core, never gets disabled.
The only other option would be marking the clock as critical
for those legacy drivers.
See also the discussions around the clock register for the
sdram clock, where we have the “normal” clock and some
pll as well - even if the “normal” clock is disabled,
then clearing the sdram register (or the parent) freezes
> Does the GPU firmware handle the SDRAM controller or is it initialized by
AFAIK it is enabled in bootcode.bin and - as of now - the firmware
updates refresh cycles when SOC temperatures change.
FW checks every 30 seconds unless there is a key set in config.txt,
which - supposedly - produces a slight impact every 30 seconds to
More information about the linux-arm-kernel