[PATCH v2] pinctrl: rockchip: fix pull setting error for rk3399

Linus Walleij linus.walleij at linaro.org
Wed May 11 01:44:36 PDT 2016


On Wed, May 11, 2016 at 5:39 AM, Caesar Wang <wxt at rock-chips.com> wrote:

> From: David Wu <david.wu at rock-chips.com>
>
> This patch fixes the pinctrl pull bias setting, since the pull up/down
> setting is the contrary for gpio0(just the gpio0a and gpio0b) and
> gpio2(just the gpio2c and gpio2d).
>
> From the TRM said, the gpio0a pull polarity setting:
> gpio0a_p
> GPIO0A PE/PS programmation section, every
> GPIO bit corresponding to 2bits[PS:PE]
> 2'b00: Z(Normal operation);
> 2'b11: weak 1(pull-up);
> 2'b01: weak 0(pull-down);
> 2'b10: Z(Normal operation);
>
> Then, the other gpios setting as the following:
> gpio1a_p (e.g.: gpio1, gpio2a, gpio2b, gpio3...)
> GPIO1A PU/PD programmation section, every
> GPIO bit corresponding to 2bits
> 2'b00: Z(Normal operation);
> 2'b01: weak 1(pull-up);
> 2'b10: weak 0(pull-down);
> 2'b11: Z(Normal operation);
>
> For example,(rk3399evb board)
> sdmmc_cd --->gpio0_a7
> localhost / # io -r -4 0xff320040
> ff320040: 00004d5f
> In general,the value should be 0x0000cd5f since the pin has been set
> in the dts.
>
> Signed-off-by: David Wu <david.wu at rock-chips.com>
> Signed-off-by: Caesar Wang <wxt at rock-chips.com>
> Cc: Linus Walleij <linus.walleij at linaro.org>
> Cc: Heiko Stuebner <heiko at sntech.de>
> Cc: linux-gpio at vger.kernel.org
> ---
>
> Changes in v2:
> - As Doug commnets on https://patchwork.kernel.org/patch/9056961/
> - update the commit for gpio2.
> - change the print error messgae.

Patch applied with the Review tags.

Yours,
Linus Walleij



More information about the linux-arm-kernel mailing list