[RFC v2 13/13] ARM: dts: exynos: Fix LAN and HUB after bootloader initialization on Odroid U3

[Javier Martinez Canillas]

Hello Krzysztof,

On 05/05/2016 08:34 AM, Krzysztof Kozlowski wrote:
> On Odroid U3 (Exynos4412-based) board if USB was initialized by
> bootloader (in U-Boot "usb start" before tftpboot), the HUB (usb3503)
> and LAN (smsc95xx) after after successful probing were not visible in the
> system ("lsusb").
> 
> In such case the devices had to be fully reset before configuring.
> Reset by GPIO (called RESET_N pin) and by RESET field in STCD register
> in usb3503 HUB are not sufficient. Instead full reset has to be done by
> disabling and enabling regulator.
> 
> Signed-off-by: Krzysztof Kozlowski <k.kozlowski at samsung.com>
> ---

[snip]

>  
> +	lan_pwrseq: pwrseq2 {
> +		compatible = "mmc-pwrseq-simple";

It feels strange to have a "mmc-pwrseq-simple" compatible for a USB power
sequence provider. As I mentioned in the other patch, I think there should
either be a DT binding for the USB pwrseq-simple with a "usb-pwrseq-simple"
compatible that binds to the same pwrseq-simple driver or maybe having a
generic DT binding for any device with a new "pwrseq-simple" compatible.

Patch looks good to me though, so after having a DT binding and changing
the compatible string:

Reviewed-by: Javier Martinez Canillas <javier at osg.samsung.com>

Best regards,
-- 
Javier Martinez Canillas
Open Source Group
Samsung Research America