[PATCH 10/12] ARM: dts: dragonboard-600c: Add on board leds support

[Rob Herring]

On Sun, Mar 27, 2016 at 12:50 AM, Bjorn Andersson
<bjorn.andersson at linaro.org> wrote:
> On Wed 23 Mar 12:48 PDT 2016, Srinivas Kandagatla wrote:
>
>> This patch adds support to 4 user leds, wlan and bt led on board.
>>
>> Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla at linaro.org>
>
> I'm not fond of the overly complicated names; and I think it should at
> least be shortened to "db600c:...".

These names are exposed to userspace. They should be the same across
all 96boards. Same goes for UART numbering and I2C bus labels on the
connector.

> Tested this on my DB600c, seems to work, except the WiFi/BT triggers,
> see comments below.
>
>> +             leds {
>> +                     pinctrl-names = "default";
>> +                     pinctrl-0 = <&user_leds>, <&mpp_leds>;
>> +
>> +                     compatible = "gpio-leds";
>> +
>> +                     led at 1 {

unit-address w/o reg property will warn on new dtc. I'd suggest
something like "userX-led".


>> +                             label = "dragonboard-600c:green:user1";
>> +                             gpios = <&tlmm_pinmux 3 GPIO_ACTIVE_HIGH>;
>> +                             linux,default-trigger = "heartbeat";
>> +                             default-state = "off";
>> +                     };