[PATCH v2 3/5] dt-bindings: phy: bindings document for common Broadcom SATA3 PHY driver

[Anup Patel]

This patch:
1. Renames DT bindings document of Broadcom STB SATA3 PHY driver to
common Broadcom SATA3 PHY driver bindings document
2. Adds bindings info for NS2 SATA3 PHY

Signed-off-by: Anup Patel <anup.patel at broadcom.com>
Acked-by: Rob Herring <robh at kernel.org>
---
 .../phy/{brcm,brcmstb-sata-phy.txt => brcm-sata-phy.txt}  | 15 +++++++++------
 1 file changed, 9 insertions(+), 6 deletions(-)
 rename Documentation/devicetree/bindings/phy/{brcm,brcmstb-sata-phy.txt => brcm-sata-phy.txt} (69%)

diff --git a/Documentation/devicetree/bindings/phy/brcm,brcmstb-sata-phy.txt b/Documentation/devicetree/bindings/phy/brcm-sata-phy.txt
similarity index 69%
rename from Documentation/devicetree/bindings/phy/brcm,brcmstb-sata-phy.txt
rename to Documentation/devicetree/bindings/phy/brcm-sata-phy.txt
index d87ab7c..d023120 100644
--- a/Documentation/devicetree/bindings/phy/brcm,brcmstb-sata-phy.txt
+++ b/Documentation/devicetree/bindings/phy/brcm-sata-phy.txt
@@ -1,14 +1,17 @@
-* Broadcom SATA3 PHY for STB
+* Broadcom SATA3 PHY
 
 Required properties:
 - compatible: should be one or more of
      "brcm,bcm7425-sata-phy"
      "brcm,bcm7445-sata-phy"
+     "brcm,iproc-ns2-sata-phy"
      "brcm,phy-sata3"
 - address-cells: should be 1
 - size-cells: should be 0
-- reg: register range for the PHY PCB interface
-- reg-names: should be "phy"
+- reg: register ranges for the PHY PCB interface
+- reg-names: should be "phy" and "phy-ctrl"
+     The "phy-ctrl" registers are only required for
+     "brcm,iproc-ns2-sata-phy".
 
 Sub-nodes:
   Each port's PHY should be represented as a sub-node.
@@ -16,12 +19,12 @@ Sub-nodes:
 Sub-nodes required properties:
 - reg: the PHY number
 - phy-cells: generic PHY binding; must be 0
-Optional:
-- brcm,enable-ssc: use spread spectrum clocking (SSC) on this port
 
+Sub-nodes optional properties:
+- brcm,enable-ssc: use spread spectrum clocking (SSC) on this port
+     This property is not applicable for "brcm,iproc-ns2-sata-phy".
 
 Example:
-
 	sata-phy at f0458100 {
 		compatible = "brcm,bcm7445-sata-phy", "brcm,phy-sata3";
 		reg = <0xf0458100 0x1e00>, <0xf045804c 0x10>;
-- 
1.9.1