[PATCH v5 2/4] Documentation: Bindings: Add STM32 DWMAC glue

[Alexandre Torgue]

Hi,

2016-03-18 17:00 GMT+01:00 Chen-Yu Tsai <wens at csie.org>:
> Hi,
>
> On Fri, Mar 18, 2016 at 11:37 PM, Alexandre TORGUE
> <alexandre.torgue at gmail.com> wrote:
>> Signed-off-by: Alexandre TORGUE <alexandre.torgue at gmail.com>
>>
>> diff --git a/Documentation/devicetree/bindings/net/stm32-dwmac.txt b/Documentation/devicetree/bindings/net/stm32-dwmac.txt
>> new file mode 100644
>> index 0000000..ada2aa4
>> --- /dev/null
>> +++ b/Documentation/devicetree/bindings/net/stm32-dwmac.txt
>> @@ -0,0 +1,32 @@
>> +STMicroelectronics STM32 / MCU DWMAC glue layer controller
>> +
>> +This file documents platform glue layer for stmmac.
>> +Please see stmmac.txt for the other unchanged properties.
>> +
>> +The device node has following properties.
>> +
>> +Required properties:
>> +- compatible:  Should be "st,stm32-dwmac" to select glue, and
>> +              "snps,dwmac-3.50a" to select IP vesrion.
>
> If you need have sort of hardware glue, then it is not compatible.
>

We could have the case where the glue is set by a bootloader.
In this case, we will select IP version in compatible and we will use
generic dwmac glue to probe stmmac driver.

Regards

Alex.

> ChenYu
>
>> +- clocks: Must contain a phandle for each entry in clock-names.
>> +- clock-names: Should be "stmmaceth" for the host clock.
>> +              Should be "tx-clk" for the MAC TX clock.
>> +              Should be "rx-clk" for the MAC RX clock.
>> +- st,syscon : Should be phandle/offset pair. The phandle to the syscon node which
>> +             encompases the glue register, and the offset of the control register.
>> +Example:
>> +
>> +               ethernet0: dwmac at 40028000 {
>> +                       compatible = "st,stm32-dwmac", "snps,dwmac-3.50a";
>> +                       status = "disabled";
>> +                       reg = <0x40028000 0x8000>;
>> +                       reg-names = "stmmaceth";
>> +                       interrupts = <0 61 0>, <0 62 0>;
>> +                       interrupt-names = "macirq", "eth_wake_irq";
>> +                       clock-names = "stmmaceth", "tx-clk", "rx-clk";
>> +                       clocks = <&rcc 0 25>, <&rcc 0 26>, <&rcc 0 27>;
>> +                       st,syscon = <&syscfg 0x4>;
>> +                       snps,pbl = <8>;
>> +                       snps,mixed-burst;
>> +                       dma-ranges;
>> +               };
>> --
>> 1.9.1
>>
>>
>> _______________________________________________
>> linux-arm-kernel mailing list
>> linux-arm-kernel at lists.infradead.org
>> http://lists.infradead.org/mailman/listinfo/linux-arm-kernel