[PATCH v4 0/4] Add Ethernet support on STM32F429

[Alexandre TORGUE]

STM32F429 Chip embeds a Synopsys 3.50a MAC IP.
This series:
 -enhance current stmmac driver to control it (code already
available) and adds basic glue for STM32F429 chip.
 -Enable basic Net config in kernel.

Note that DT patches are not present because STM32 pinctrl code is not
yet avalaible.

Changes since v3:
 -Fix "tx-clk" and "rx-clk" as required clocks. Driver and bindings are
modified.

Changes since v2:
 -Fix alphabetic order in Kconfig and Makefile.
 -Improve code according to Joachim review.
 -Binding: remove useless entry.

Changes since v1:
 -Fix Kbuild issue in Kconfig.
 -Remove init/exit callbacks. Suspend/Resume and remove driver is no more
driven in stmmac_pltfr but directly in dwmac-stm32 glue driver.
 -Take into account Joachim review.

Regards.

Alexandre.

Alexandre TORGUE (4):
  net: ethernet: dwmac: add Ethernet glue logic for stm32 chip
  Documentation: Bindings: Add STM32 DWMAC glue
  net: ethernet: stmmac: add support of Synopsys 3.50a MAC IP
  ARM: STM32: Enable Ethernet in stm32_defconfig

 .../devicetree/bindings/net/stm32-dwmac.txt        |  35 ++++
 arch/arm/configs/stm32_defconfig                   |   9 +
 drivers/net/ethernet/stmicro/stmmac/Kconfig        |  12 ++
 drivers/net/ethernet/stmicro/stmmac/Makefile       |   1 +
 drivers/net/ethernet/stmicro/stmmac/dwmac-stm32.c  | 193 +++++++++++++++++++++
 .../net/ethernet/stmicro/stmmac/stmmac_platform.c  |   1 +
 6 files changed, 251 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/net/stm32-dwmac.txt
 create mode 100644 drivers/net/ethernet/stmicro/stmmac/dwmac-stm32.c

-- 
1.9.1