[PATCH 06/21] usb: chipidea: Initialize and reinitialize phy later

[Stephen Boyd]

Quoting Peter Chen (2016-06-28 19:30:52)
> On Sun, Jun 26, 2016 at 12:28:23AM -0700, Stephen Boyd wrote:
> > The ULPI phy on qcom platforms needs to be initialized and
> > powered on after a USB reset and before we toggle the run/stop
> > bit. Otherwise, the phy locks up and doesn't work properly.
> 
> This requirement is so strange, try to see if any other initialization
> sequences.

I think the problem is that the reset bit also resets the phy because
the phy is part of the same clock domain as the controller. Just a guess
though.

>      
> Since this driver is multi-platforms, I can't accept this change for
> common, if you had to do that, would you please move your changes to
> msm glue layer using CI_HDRC_CONTROLLER_RESET_EVENT and
> CI_HDRC_CONTROLLER_STOPPED_EVENT? Besides, you need to add one flag
> at ci_hdrc_platform_data.flags for your case to avoid normal
> initialization.

Ok, let me see if I can make this work properly in the glue layer. I
take it that you want me to add a flag for this specific case so that we
don't do any phy control in the core and leave it up to the glue layer
to handle, like CI_HDRC_DISABLE_PHY_CONTROL or something?