[PATCH v2 0/5] s3c64xx: consider the case of a disconnected CS line and some code rework

[Andi Shyti]

Hi,

the main goal of the patchset is to support SPI cnnected device
without CS line link.

The first two patches make the s3c64xx driver to consider the
case of a disconnected CS line. This is done by adding a property
in the DTS ("no-cs-readback") which informs the device driver the
absence of a chip selection link.

The last three patches are just some code re-work and
beautification.

Changelog: V1 -> V2

 - the first version of the patchset was removing an 'if'
   statement on "!spi->chip_select" which was causing the SPI
   core to fail. In this case the drivers would have been able to
   set a chip_select = 0 in absence of a CS link. After a short
   discussion with Mark, this has been replaced, as described
   above, by a property in the DTS.

 - one more patch has been added which assigns to some variable
   the proper type

 - some typos fixed in the commit messages

Thanks,
Andi

Andi Shyti (5):
  spi: s3c64xx: group the CS signalling writes in a single function
  spi: s3c64xx: consider the case when the CS line is not connected
  spi: s3c64xx: do not configure the device twice
  spi: s3c64xx: simplify if statement in prepare_transfer function
  spi: s3c64xx: use unsigned type for fifo handling variables

 .../devicetree/bindings/spi/spi-samsung.txt        |   3 +
 drivers/spi/spi-s3c64xx.c                          | 114 +++++++++++----------
 include/linux/platform_data/spi-s3c64xx.h          |   1 +
 3 files changed, 65 insertions(+), 53 deletions(-)

-- 
2.8.1