[PATCHv5 6/8] EDAC, altera: Add Arria10 ECC memory init functions
tthayer at opensource.altera.com
tthayer at opensource.altera.com
Wed Jun 22 06:58:57 PDT 2016
From: Thor Thayer <tthayer at opensource.altera.com>
In preparation for additional memory module ECCs, add the
memory initialization functions and helper functions used
for memory initialization.
Signed-off-by: Thor Thayer <tthayer at opensource.altera.com>
---
v2: Specify INTMODE selection -> IRQ on each ECC error.
Insert functions above memory-specific functions so that function
declarations are not required.
Use ERRINTENS & ERRINTENR registers instead of read/modify/write.
v3: Changes for common compatibility string:
- Pass node instead of compatibility string.
- New altr_init_a10_ecc_device_type() for peripherals.
- Add __init to altr_init_a10_ecc_block().
- Add a10_get_irq_mask().
v4 Replace ifdefs with __maybe_unused macro
Improve if,else statement in altr_init_memory_port()
Remove confusing comment about shared function.
v5 No change
---
drivers/edac/altera_edac.c | 192 ++++++++++++++++++++++++++++++++++++++++++++
drivers/edac/altera_edac.h | 8 ++
2 files changed, 200 insertions(+)
diff --git a/drivers/edac/altera_edac.c b/drivers/edac/altera_edac.c
index 2e5940e..6091b76 100644
--- a/drivers/edac/altera_edac.c
+++ b/drivers/edac/altera_edac.c
@@ -19,6 +19,7 @@
#include <asm/cacheflush.h>
#include <linux/ctype.h>
+#include <linux/delay.h>
#include <linux/edac.h>
#include <linux/genalloc.h>
#include <linux/interrupt.h>
@@ -874,6 +875,197 @@ static irqreturn_t __maybe_unused altr_edac_a10_ecc_irq(int irq, void *dev_id)
return IRQ_NONE;
}
+/******************* Arria10 Memory Buffer Functions *********************/
+
+static inline int a10_get_irq_mask(struct device_node *np)
+{
+ int irq;
+ const u32 *handle = of_get_property(np, "interrupts", NULL);
+
+ if (!handle)
+ return -ENODEV;
+ irq = be32_to_cpup(handle);
+ return irq;
+}
+
+static inline void ecc_set_bits(u32 bit_mask, void __iomem *ioaddr)
+{
+ u32 value = readl(ioaddr);
+
+ value |= bit_mask;
+ writel(value, ioaddr);
+}
+
+static inline void ecc_clear_bits(u32 bit_mask, void __iomem *ioaddr)
+{
+ u32 value = readl(ioaddr);
+
+ value &= ~bit_mask;
+ writel(value, ioaddr);
+}
+
+static inline int ecc_test_bits(u32 bit_mask, void __iomem *ioaddr)
+{
+ u32 value = readl(ioaddr);
+
+ return (value & bit_mask) ? 1 : 0;
+}
+
+/*
+ * This function uses the memory initialization block in the Arria10 ECC
+ * controller to initialize/clear the entire memory data and ECC data.
+ */
+static int __maybe_unused altr_init_memory_port(void __iomem *ioaddr, int port)
+{
+ int limit = ALTR_A10_ECC_INIT_WATCHDOG_10US;
+ u32 init_mask, stat_mask, clear_mask;
+ int ret = 0;
+
+ if (port) {
+ init_mask = ALTR_A10_ECC_INITB;
+ stat_mask = ALTR_A10_ECC_INITCOMPLETEB;
+ clear_mask = ALTR_A10_ECC_ERRPENB_MASK;
+ } else {
+ init_mask = ALTR_A10_ECC_INITA;
+ stat_mask = ALTR_A10_ECC_INITCOMPLETEA;
+ clear_mask = ALTR_A10_ECC_ERRPENA_MASK;
+ }
+
+ ecc_set_bits(init_mask, (ioaddr + ALTR_A10_ECC_CTRL_OFST));
+ while (limit--) {
+ if (ecc_test_bits(stat_mask,
+ (ioaddr + ALTR_A10_ECC_INITSTAT_OFST)))
+ break;
+ udelay(1);
+ }
+ if (limit < 0)
+ ret = -EBUSY;
+
+ /* Clear any pending ECC interrupts */
+ writel(clear_mask, (ioaddr + ALTR_A10_ECC_INTSTAT_OFST));
+
+ return ret;
+}
+
+static __init int __maybe_unused
+altr_init_a10_ecc_block(struct device_node *np, u32 irq_mask,
+ u32 ecc_ctrl_en_mask, bool dual_port)
+{
+ int ret = 0;
+ void __iomem *ecc_block_base;
+ struct regmap *ecc_mgr_map;
+ char *ecc_name;
+ struct device_node *np_eccmgr;
+
+ ecc_name = (char *)np->name;
+
+ /* Get the ECC Manager - parent of the device EDACs */
+ np_eccmgr = of_get_parent(np);
+ ecc_mgr_map = syscon_regmap_lookup_by_phandle(np_eccmgr,
+ "altr,sysmgr-syscon");
+ of_node_put(np_eccmgr);
+ if (IS_ERR(ecc_mgr_map)) {
+ edac_printk(KERN_ERR, EDAC_DEVICE,
+ "Unable to get syscon altr,sysmgr-syscon\n");
+ return -ENODEV;
+ }
+
+ /* Map the ECC Block */
+ ecc_block_base = of_iomap(np, 0);
+ if (!ecc_block_base) {
+ edac_printk(KERN_ERR, EDAC_DEVICE,
+ "Unable to map %s ECC block\n", ecc_name);
+ return -ENODEV;
+ }
+
+ /* Disable ECC */
+ regmap_write(ecc_mgr_map, A10_SYSMGR_ECC_INTMASK_SET_OFST, irq_mask);
+ writel(ALTR_A10_ECC_SERRINTEN,
+ (ecc_block_base + ALTR_A10_ECC_ERRINTENR_OFST));
+ ecc_clear_bits(ecc_ctrl_en_mask,
+ (ecc_block_base + ALTR_A10_ECC_CTRL_OFST));
+ /* Ensure all writes complete */
+ wmb();
+ /* Use HW initialization block to initialize memory for ECC */
+ ret = altr_init_memory_port(ecc_block_base, 0);
+ if (ret) {
+ edac_printk(KERN_ERR, EDAC_DEVICE,
+ "ECC: cannot init %s PORTA memory\n", ecc_name);
+ goto out;
+ }
+
+ if (dual_port) {
+ ret = altr_init_memory_port(ecc_block_base, 1);
+ if (ret) {
+ edac_printk(KERN_ERR, EDAC_DEVICE,
+ "ECC: cannot init %s PORTB memory\n",
+ ecc_name);
+ goto out;
+ }
+ }
+
+ /* Interrupt mode set to every SBERR */
+ regmap_write(ecc_mgr_map, ALTR_A10_ECC_INTMODE_OFST,
+ ALTR_A10_ECC_INTMODE);
+ /* Enable ECC */
+ ecc_set_bits(ecc_ctrl_en_mask, (ecc_block_base +
+ ALTR_A10_ECC_CTRL_OFST));
+ writel(ALTR_A10_ECC_SERRINTEN,
+ (ecc_block_base + ALTR_A10_ECC_ERRINTENS_OFST));
+ regmap_write(ecc_mgr_map, A10_SYSMGR_ECC_INTMASK_CLR_OFST, irq_mask);
+ /* Ensure all writes complete */
+ wmb();
+out:
+ iounmap(ecc_block_base);
+ return ret;
+}
+
+static int validate_parent_available(struct device_node *np);
+static const struct of_device_id altr_edac_a10_device_of_match[];
+static int __init __maybe_unused altr_init_a10_ecc_device_type(char *compat)
+{
+ int irq;
+ struct device_node *child, *np = of_find_compatible_node(NULL, NULL,
+ "altr,socfpga-a10-ecc-manager");
+ if (!np) {
+ edac_printk(KERN_ERR, EDAC_DEVICE, "ECC Manager not found\n");
+ return -ENODEV;
+ }
+
+ for_each_child_of_node(np, child) {
+ const struct of_device_id *pdev_id;
+ const struct edac_device_prv_data *prv;
+
+ if (!of_device_is_available(child))
+ continue;
+ if (!of_device_is_compatible(child, compat))
+ continue;
+
+ if (validate_parent_available(child))
+ continue;
+
+ irq = a10_get_irq_mask(child);
+ if (irq < 0)
+ continue;
+
+ /* Get matching node and check for valid result */
+ pdev_id = of_match_node(altr_edac_a10_device_of_match, child);
+ if (IS_ERR_OR_NULL(pdev_id))
+ continue;
+
+ /* Validate private data pointer before dereferencing */
+ prv = pdev_id->data;
+ if (!prv)
+ continue;
+
+ altr_init_a10_ecc_block(child, BIT(irq),
+ prv->ecc_enable_mask, 0);
+ }
+
+ of_node_put(np);
+ return 0;
+}
+
/*********************** OCRAM EDAC Device Functions *********************/
#ifdef CONFIG_EDAC_ALTERA_OCRAM
diff --git a/drivers/edac/altera_edac.h b/drivers/edac/altera_edac.h
index cf4e8cb..aa7c690 100644
--- a/drivers/edac/altera_edac.h
+++ b/drivers/edac/altera_edac.h
@@ -230,8 +230,13 @@ struct altr_sdram_mc_data {
#define ALTR_A10_ECC_INITCOMPLETEB BIT(8)
#define ALTR_A10_ECC_ERRINTEN_OFST 0x10
+#define ALTR_A10_ECC_ERRINTENS_OFST 0x14
+#define ALTR_A10_ECC_ERRINTENR_OFST 0x18
#define ALTR_A10_ECC_SERRINTEN BIT(0)
+#define ALTR_A10_ECC_INTMODE_OFST 0x1C
+#define ALTR_A10_ECC_INTMODE BIT(0)
+
#define ALTR_A10_ECC_INTSTAT_OFST 0x20
#define ALTR_A10_ECC_SERRPENA BIT(0)
#define ALTR_A10_ECC_DERRPENA BIT(8)
@@ -280,6 +285,9 @@ struct altr_sdram_mc_data {
/* Arria 10 OCRAM ECC Management Group Defines */
#define ALTR_A10_OCRAM_ECC_EN_CTL (BIT(1) | BIT(0))
+/* A10 ECC Controller memory initialization timeout */
+#define ALTR_A10_ECC_INIT_WATCHDOG_10US 10000
+
struct altr_edac_device_dev;
struct edac_device_prv_data {
--
1.7.9.5
More information about the linux-arm-kernel
mailing list