[PATCH 1/2] i2c: qup: Cleared the error bits in ISR

[Abhishek Sahu]

On 2016-06-18 22:02, Wolfram Sang wrote:
>> We run the command i2cdetect for address 0x3 to 0x77. The QUP 
>> generates
>> write error for address 0x3 to 0x7 apart from other bus errors since
>> these are reserved addresses. I was getting the crash in non DMA mode
>> and BAM hang in DMA mode before putting the fix.
>> 
>> Also we have connected the I2C TPM and run the following script
>> overnight for both DMA and Non DMA mode.  The script checks for
>> all transfer length and we are generating multiple NACK and
>> Non NACK error before each valid transfer.
>> 
>> a=1
>> 
>> while [ $a -lt 4096 ]
>> do
>>    echo $a
>>    i2cdetect -y -a -r 0 0x03 0x77
>>    tpm-manager get_random $a
>>    i2cdetect -y -a -r 1 0x03 0x77
>>    a=`expr $a + 1`
>> done
> 
> So, what is the outcome of this discussion?

Discussion was regarding resetting the QUP state in ISR and it is the 
part of
existing code itself. The current patch only added the error checking 
for bus
errors so we can go ahead with this patch. I have shared the script 
which we
are using for testing error path.