[PATCH v3 08/20] pwm: Add PWM Capture support
lee.jones at linaro.org
Mon Jun 20 04:14:42 PDT 2016
On Fri, 10 Jun 2016, Thierry Reding wrote:
> On Fri, Jun 10, 2016 at 03:38:54PM +0100, Lee Jones wrote:
> > On Fri, 10 Jun 2016, Thierry Reding wrote:
> > > On Wed, Jun 08, 2016 at 10:21:23AM +0100, Lee Jones wrote:
> > > > Supply a PWM Capture call-back Op in order to pass back
> > > > information obtained by running analysis on PWM a signal.
> > > > This would normally (at least during testing) be called from
> > > > the Sysfs routines with a view to printing out PWM Capture
> > > > data which has been encoded into a string.
> > > >
> > > > Signed-off-by: Lee Jones <lee.jones at linaro.org>
> > > > ---
> > > > drivers/pwm/core.c | 27 +++++++++++++++++++++++++++
> > > > include/linux/pwm.h | 25 +++++++++++++++++++++++++
> > > > 2 files changed, 52 insertions(+)
> > So do you want me to re-spin?
> > Before you said you'd make adjustments on patches 8 through 10, so I'm
> > a little confused.
> Yeah, I only realized that it might be quicker to make these adjustments
> myself when I had finished looking at patch 10. I've pushed the adjusted
> patches to a for-4.8/pwm-capture branch, so if you're going to re-spin
> the remainder of the patches, perhaps that could be your base?
> If you don't have any objections I can put those into linux-next early
> next week.
That's fine by me. I will rebase.
Linaro STMicroelectronics Landing Team Lead
Linaro.org │ Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog
More information about the linux-arm-kernel