kexec failures with DEBUG_RODATA

Kees Cook keescook at google.com
Tue Jun 14 11:05:23 PDT 2016


On Tue, Jun 14, 2016 at 10:59 AM, Russell King - ARM Linux
<linux at armlinux.org.uk> wrote:
> Guys,
>
> Having added Keystone2 support to kexec, and asking TI to validate
> linux-next with mainline kexec-tools, I received two reports from
> them.
>
> The first was a report of success, but was kexecing a 4.4 kernel
> from linux-next.
>
> The second was a failure report, kexecing current linux-next from
> linux-next on this platform.  However, my local tests (using my
> 4.7-rc3 derived kernel) showed there to be no problem.
>
> Building my 4.7-rc3 derived kernel with TI's configuration they
> were using with linux-next similarly failed.  So, it came down to
> a configuration difference.
>
> After trialling several configurations, it turns out that the
> failure is, in part, caused by CONFIG_DEBUG_RODATA being enabled
> on TI's kernel but not mine.  Why should this make any difference?
>
> Well, CONFIG_DEBUG_RODATA has the side effect that the kernel
> contains a lot of additional padding - we pad out to section size
> (1MB) the ELF sections with differing attributes.  This should not
> normally be a problem, except kexec contains this assumption:
>
>                 /* Otherwise, assume the maximum kernel compression ratio
>                  * is 4, and just to be safe, place ramdisk after that */
>                 initrd_base = base + _ALIGN(len * 4, getpagesize());
>
> Now, first things first.  Don't get misled by the comment - it's
> totally false.  That may be what's desired, but that is far from
> what actually happens in reality.
>
> "base" is _not_ the address of the start of the kernel image, but
> is the base address of the start of the region that the kernel is
> to be loaded into - remember that the kernel is normally loaded
> 32k higher than the start of memory.  This 32k offset is _not_
> included in either "base" nor "len".  So, even if we did want to
> assume that there was a maximum compression ratio of 4, the above
> always calculates 32k short of that value.
>
> The other invalid thing here is this whole "maximum kernel compression
> ratio" assumption.  Consider this non-DEBUG_RODATA kernel image:
>
>    text    data     bss     dec     hex filename
> 6583513 2273816  215344 9072673  8a7021 ../build/ks2/vmlinux
>
> This results in an image and zimage of:
> -rwxrwxr-x 1 rmk rmk 8871936 Jun 14 18:02 ../build/ks2/arch/arm/boot/Image
> -rwxrwxr-x 1 rmk rmk 4381592 Jun 14 18:02 ../build/ks2/arch/arm/boot/zImage
>
> which is a ratio of about a 49%.  On entry to the decompressor, the
> compressed image will be relocated above the expected resulting
> kernel size.  So, let's say that it's relocated to 9MB.  This means
> the zImage will occupy around 9MB-14MB above the start of memory.
> Going by the 4x ratio, we place the other images at 16.7MB.  This
> leaves around 2.7MB free.  So that's probably fine... but think
> about this.  We assumed a ratio of 4x, but really we're in a rather
> tight squeeze - we actually have only about 50% of the compressed
> image size spare.
>
> Now let's look at the DEBUG_RODATA case:
>
>    text    data     bss     dec     hex filename
> 6585305 2273952  215344 9074601  8a77a9 ../build/ks2/vmlinux
>
> And the resulting sizes:
> -rwxrwxr-x 1 rmk rmk 15024128 Jun 14 18:49 ../build/ks2/arch/arm/boot/Image
> -rwxrwxr-x 1 rmk rmk  4399040 Jun 14 18:49 ../build/ks2/arch/arm/boot/zImage
>
> That's a compression ratio of about 29%.  Still within the 4x limit,
> but going through the same calculation above shows that we end up
> totally overflowing the available space this time.
>
> That's exactly the same kernel configuration except for
> CONFIG_DEBUG_RODATA - enabling this has almost _doubled_ the
> decompressed image size without affecting the compressed size.
>
> We've known for some time that this ratio of 4x doesn't work - we
> used to use the same assumption in the decompressor when self-
> relocating, and we found that there are images which achieve a
> better compression ratio and make this invalid.  Yet, the 4x thing
> has persisted in kexec code... and buggily too.
>
> Since the kernel now has CONFIG_DEBUG_RODATA by default, this means
> that these kinds of ratio-based assumptions are even more invalid
> than they have been.
>
> Right now, a zImage doesn't advertise the size of its uncompressed
> image, but I think with things like CONFIG_DEBUG_RODATA, we can no
> longer make assumptions like we have done in the past, and we need
> the zImage to provide this information so that the boot environment
> can be setup sanely by boot loaders/kexec rather than relying on
> broken heuristics like this.
>
> Thoughts?

I'm much less familiar with the ARM decompression stub, but is there a
boot image header (like x86 has)? If not, perhaps we can invent one,
and it can carry all the details needed for a bootloader to do the
right things.

-Kees

-- 
Kees Cook
Chrome OS & Brillo Security



More information about the linux-arm-kernel mailing list