[PATCH 00/14] run seccomp after ptrace

[Kees Cook]

(Oops, forgot to send this series through the lsm list...)

On Thu, Jun 9, 2016 at 2:01 PM, Kees Cook <keescook at chromium.org> wrote:
> There has been a long-standing (and documented) issue with seccomp
> where ptrace can be used to change a syscall out from under seccomp.
> This is a problem for containers and other wider seccomp filtered
> environments where ptrace needs to remain available, as it allows
> for an escape of the seccomp filter.
>
> Since the ptrace attack surface is available for any allowed syscall,
> moving seccomp after ptrace doesn't increase the actually available
> attack surface. And this actually improves tracing since, for
> example, tracers will be notified of syscall entry before seccomp
> sends a SIGSYS, which makes debugging filters much easier.
>
> The per-architecture changes do make one (hopefully small)
> semantic change, which is that since ptrace comes first, it may
> request a syscall be skipped. Running seccomp after this doesn't
> make sense, so if ptrace wants to skip a syscall, it will bail
> out early similarly to how seccomp was. This means that skipped
> syscalls will not be fed through audit, though that likely means
> we're actually avoiding noise this way.
>
> This series first cleans up seccomp to remove the now unneeded
> two-phase entry, fixes the SECCOMP_RET_TRACE hole (same as the
> ptrace hole above), and then reorders seccomp after ptrace on
> each architecture.

Has anyone else had a chance to review this series? I'd like to get it
landed in -next as early as possible in case there are unexpected
problems...

-Kees

-- 
Kees Cook
Chrome OS & Brillo Security