[PATCH V2 4/4] ARM: mxs: dts: Add SanDisk Sansa Fuze+ support

[Shawn Guo]

On Thu, Jun 09, 2016 at 03:30:16AM +0200, Marek Vasut wrote:
> On 06/09/2016 03:21 AM, Shawn Guo wrote:
> > On Sun, May 08, 2016 at 10:50:21PM +0200, Marek Vasut wrote:
> >> +	regulators {
> >> +		compatible = "simple-bus";
> >> +
> >> +		reg_vddio_sd0: vddio-sd0 {
> > 
> > Put fixed regulator nodes directly under root with suggested naming
> > scheme.
> > 
> >> +			compatible = "regulator-fixed";
> >> +			regulator-name = "vddio-sd0";
> >> +			regulator-min-microvolt = <3300000>;
> >> +			regulator-max-microvolt = <3300000>;
> >> +			gpio = <&gpio0 8 0>;
> >> +		};
> >> +
> >> +		reg_vddio_sd1: vddio-sd1 {
> >> +			compatible = "regulator-fixed";
> >> +			regulator-name = "vddio-sd1";
> >> +			regulator-min-microvolt = <3300000>;
> >> +			regulator-max-microvolt = <3300000>;
> >> +			gpio = <&gpio1 29 0>;
> >> +		};
> >> +
> >> +		reg_vdd_touchpad: vdd-touchpad0 {
> >> +			compatible = "regulator-fixed";
> >> +			regulator-name = "vdd-touchpad0";
> >> +			regulator-min-microvolt = <3300000>;
> >> +			regulator-max-microvolt = <3300000>;
> >> +			gpio = <&gpio0 26 0>;
> >> +			regulator-always-on;
> >> +			enable-active-low;
> >> +		};
> >> +
> >> +		reg_vdd_tuner: vdd-tuner0 {
> >> +			compatible = "regulator-fixed";
> >> +			regulator-name = "vdd-tuner0";
> >> +			regulator-min-microvolt = <3300000>;
> >> +			regulator-max-microvolt = <3300000>;
> >> +			gpio = <&gpio0 29 0>;
> >> +			regulator-always-on;
> >> +			enable-active-low;
> >> +		};
> >> +	};
> >> +
> >> +	backlight {
> >> +		compatible = "pwm-backlight";
> >> +		pwms = <&pwm 2 5000000>;
> >> +		brightness-levels = <0 4 8 16 32 64 128 255>;
> >> +		default-brightness-level = <6>;
> >> +	};
> >> +
> >> +	i2c at 0 {
> > 
> > The @unit-address should be used for nodes with 'reg' property.
> 
> Can you please do such minor fixes when applying or do you expect a resend ?

Such minor fixes are just too many to be fixed by myself.  Please
resend.

Shawn