[PATCH] ARM: imx25-pinfunc: remove SION from all modes

[Shawn Guo]

On Fri, Jun 03, 2016 at 03:32:47PM +0200, Uwe Kleine-König wrote:
> I found a regression of the patch under discussion (which was not
> applied, so no big problem). On the custom mx25 based hardware an
> SD-card isn't detected any more after removing SION from
> MX25_PAD_SD1_CMD__SD1_CMD. I verified the same happens on a tx25.
> 
> Is this expected? IMHO it's unfortunate (if not a silicon bug) that you
> need the SION bit here as the SION bit has some more side effects.  If
> you ask me, muxing a certain function for a pin should enable the input
> path to the respective module if the pin is bidirectional.
> 
> Is there a list of pin/function pairs that need the SION bit set? Shawn,
> would you agree to accept this patch with the high risk that it
> introduces regressions? Or maybe we should make the SION bit more easily
> overridable for board dts files (and default to off unless known it's
> needed)?

I would be conservative on this.  Can we just fix the SION bits that are
known doing harm?

Shawn