[PATCH 2/5] i2c: Add STM32F4 I2C driver

[Maxime Coquelin]

2016-06-01 16:01 GMT+02:00 M'boumba Cedric Madianga <cedric.madianga at gmail.com>:
> Hi Maxime,
>
>>>> +static void stm32f4_i2c_set_speed_mode(struct stm32f4_i2c_dev *i2c_dev)
>>>> +{
>>>> +       struct stm32f4_i2c_timings *t = &i2c_timings[i2c_dev->speed];
>>>> +       u32 ccr, val, clk_rate;
>>>> +
>>>> +       ccr = readl_relaxed(i2c_dev->base + STM32F4_I2C_CCR);
>>>> +       ccr &= ~(STM32F4_I2C_CCR_FS | STM32F4_I2C_CCR_DUTY |
>>>> +                STM32F4_I2C_CCR_CCR_MASK);
>>>> +
>>>> +       clk_rate = clk_get_rate(i2c_dev->clk);
>>>> +
>>>> +       switch (i2c_dev->speed) {
>>>> +       case STM32F4_I2C_SPEED_STANDARD:
>>>> +               val = clk_rate / t->rate * 2;
>>>> +               if (val < STM32F4_I2C_MIN_CCR)
>>>> +                       ccr |= STM32F4_I2C_CCR_CCR(STM32F4_I2C_MIN_CCR);
>>>> +               else
>>>> +                       ccr |= STM32F4_I2C_CCR_CCR(val);
>>>> +               break;
>>>> +       case STM32F4_I2C_SPEED_FAST:
>>>> +               ccr |= STM32F4_I2C_CCR_FS;
>>>> +               if (t->duty) {
>>>> +                       ccr |= STM32F4_I2C_CCR_DUTY;
>>>> +                       ccr |= STM32F4_I2C_CCR_CCR(clk_rate / t->rate * 25);
>>>> +               } else {
>>>> +                       ccr |= STM32F4_I2C_CCR_CCR(clk_rate / t->rate * 3);
>>>> +               }
>>> Is it really useful since duty seems to always be 0?
>> Agree, I will rework it by directly set duty at 0 in the register.
>
> Contrary to what I wrote previously, the duty has to be set for FAST
> Mode to reach 400khz.
> So, I am going to keep the timing struct and set duty to 1 for FAST mode

Ok, That's fine by me.