[PATCH v3 0/4] Amlogic: Meson: Add reset controller

[Philipp Zabel]

Hi Kevin,

Am Montag, den 30.05.2016, 15:27 +0200 schrieb Neil Armstrong:
> Patchset to add and enable the reset controller driver on Meson SoCs platforms.
> 
> This reset controller has up to 256 reset lines with reset pulse generation only,
> so the assert and deassert calls are not available.
> 
> Depends on the patch :
>  - "reset: add devm_reset_controller_register API" [1]
> 
> Changes since v2 at http://lkml.kernel.org/r/1464169758-26975-1-git-send-email-narmstrong@baylibre.com :
> - Get back __iomem in _reset() callback
> - Get rid of MODULE_ALIAS
> 
> Changes since v1 at http://lkml.kernel.org/r/1463732875-23141-1-git-send-email-narmstrong@baylibre.com :
> - Remove _gxbb_ in names
> - Depends build on ARCH_MESON only
> - Add meson8b compatible and bindings
> - Re-indent dt-bindings headers
> - Switch to devm_ reset controller register
> - Remove platform "remove" callback
> - Update Dual BSD/GPL file headers
> 
> Changes since the RFC at http://lkml.kernel.org/r/1463148012-25988-1-git-send-email-narmstrong@baylibre.com :
> - Fix register mapping and bit defines in bindings header
> - Remove assert and unassert calls
> - Fix missing __iomem
> 
> [1] https://patchwork.kernel.org/patch/8988471/
> 
> Neil Armstrong (4):
>   reset: Add support for the Amlogic Meson SoC Reset Controller
>   dt-bindings: reset: Add bindings for the Meson SoC Reset Controller
>   ARM64: dts: amlogic: Enable Reset Controller on GXBB-based platforms
>   ARM: dts: amlogic: Enable Reset Controller on Meson8b platforms

Should I take the two device tree patches into the reset tree?
Is resolving the reset/deassert situation a prerequisite for these
patches?

regards
Philipp