[PATCH v7 2/2] [media] atmel-isc: DT binding for Image Sensor Controller driver

[Rob Herring]

On Sun, Jul 31, 2016 at 8:23 PM, Wu, Songjun <Songjun.Wu at microchip.com> wrote:
>
>
> On 7/30/2016 05:44, Rob Herring wrote:
>>
>> On Fri, Jul 29, 2016 at 03:54:08PM +0800, Songjun Wu wrote:
>>>
>>> DT binding documentation for ISC driver.
>>>
>>> Signed-off-by: Songjun Wu <songjun.wu at microchip.com>
>>> ---
>>>
>>> Changes in v7: None
>>> Changes in v6:
>>> - Add "iscck" and "gck" to clock-names.
>>>
>>> Changes in v5:
>>> - Add clock-output-names.
>>>
>>> Changes in v4:
>>> - Remove the isc clock nodes.
>>>
>>> Changes in v3:
>>> - Remove the 'atmel,sensor-preferred'.
>>> - Modify the isc clock node according to the Rob's remarks.
>>>
>>> Changes in v2:
>>> - Remove the unit address of the endpoint.
>>> - Add the unit address to the clock node.
>>> - Avoid using underscores in node names.
>>> - Drop the "0x" in the unit address of the i2c node.
>>> - Modify the description of 'atmel,sensor-preferred'.
>>> - Add the description for the ISC internal clock.
>>>
>>>  .../devicetree/bindings/media/atmel-isc.txt        | 65
>>> ++++++++++++++++++++++
>>>  1 file changed, 65 insertions(+)
>>>  create mode 100644 Documentation/devicetree/bindings/media/atmel-isc.txt
>>
>>
>> Please add acks when posting new versions.
>>
>> Rob
>>
> Hi Rob,
>
> Thank you for your reminder.
>
> Should I Add 'Acked-by: Rob Herring <robh at kernel.org>' behind
> 'Signed-off-by: Songjun Wu <songjun.wu at microchip.com>'?

Before or after is fine.

> Should I resend this patch?

Not just to add acks, but if you send v8, add the acks.

Rob