[PATCH] ata: xgene: Enable NCQ support for APM X-Gene SATA controller hardware v1.1

[Rameshwar Prasad Sahu]

This patch enables NCQ support for APM X-Gene SATA controller
hardware v1.1 that was broken with hardware v1.0.

Signed-off-by: Rameshwar Prasad Sahu <rsahu at apm.com>
---
 drivers/ata/ahci_xgene.c |   14 ++++++++------
 1 files changed, 8 insertions(+), 6 deletions(-)

diff --git a/drivers/ata/ahci_xgene.c b/drivers/ata/ahci_xgene.c
index 73b19b2..8b88be9 100644
--- a/drivers/ata/ahci_xgene.c
+++ b/drivers/ata/ahci_xgene.c
@@ -87,6 +87,7 @@

 enum xgene_ahci_version {
 	XGENE_AHCI_V1 = 1,
+	XGENE_AHCI_V1_1,
 	XGENE_AHCI_V2,
 };

@@ -734,6 +735,7 @@ static struct scsi_host_template ahci_platform_sht = {
 #ifdef CONFIG_ACPI
 static const struct acpi_device_id xgene_ahci_acpi_match[] = {
 	{ "APMC0D0D", XGENE_AHCI_V1},
+	{ "APMC0D67", XGENE_AHCI_V1_1},
 	{ "APMC0D32", XGENE_AHCI_V2},
 	{},
 };
@@ -742,6 +744,7 @@ MODULE_DEVICE_TABLE(acpi, xgene_ahci_acpi_match);

 static const struct of_device_id xgene_ahci_of_match[] = {
 	{.compatible = "apm,xgene-ahci", .data = (void *) XGENE_AHCI_V1},
+	{.compatible = "apm,xgene-ahci-v1-1", .data = (void *) XGENE_AHCI_V1_1},
 	{.compatible = "apm,xgene-ahci-v2", .data = (void *) XGENE_AHCI_V2},
 	{},
 };
@@ -755,8 +758,7 @@ static int xgene_ahci_probe(struct platform_device *pdev)
 	struct resource *res;
 	const struct of_device_id *of_devid;
 	enum xgene_ahci_version version = XGENE_AHCI_V1;
-	const struct ata_port_info *ppi[] = { &xgene_ahci_v1_port_info,
-					      &xgene_ahci_v2_port_info };
+	const struct ata_port_info *ppi;
 	int rc;

 	hpriv = ahci_platform_get_resources(pdev);
@@ -821,8 +823,6 @@ static int xgene_ahci_probe(struct platform_device *pdev)
 				dev_warn(&pdev->dev, "%s: Error reading device info. Assume version1\n",
 					__func__);
 				version = XGENE_AHCI_V1;
-			} else if (info->valid & ACPI_VALID_CID) {
-				version = XGENE_AHCI_V2;
 			}
 		}
 	}
@@ -858,18 +858,20 @@ skip_clk_phy:

 	switch (version) {
 	case XGENE_AHCI_V1:
+		ppi = &xgene_ahci_v1_port_info;
 		hpriv->flags = AHCI_HFLAG_NO_NCQ;
 		break;
 	case XGENE_AHCI_V2:
+		ppi = &xgene_ahci_v2_port_info;
 		hpriv->flags |= AHCI_HFLAG_YES_FBS;
 		hpriv->irq_handler = xgene_ahci_irq_intr;
 		break;
 	default:
+		ppi = &xgene_ahci_v1_port_info;
 		break;
 	}

-	rc = ahci_platform_init_host(pdev, hpriv, ppi[version - 1],
-				     &ahci_platform_sht);
+	rc = ahci_platform_init_host(pdev, hpriv, ppi, &ahci_platform_sht);
 	if (rc)
 		goto disable_resources;

--
1.7.1