[PATCH 2/3] regulator: qcom_smd: Fix voltage ranges for pma8084 ftsmps and pldo

Andy Gross andy.gross at linaro.org
Mon Jul 11 15:38:27 PDT 2016


On Mon, Jul 11, 2016 at 02:50:08PM -0700, Stephen Boyd wrote:
> The voltage ranges listed here are wrong. The pma8084 pldo
> supports three different overlapping voltage ranges with
> differing step sizes and the pma8084 ftsmps supports two. These
> ranges can be seen in the "native" spmi regulator driver
> (qcom_spmi-regulator.c) at pldo_ranges[] and ftsmps_ranges[]
> respectively. Port these ranges over to the RPM SMD regulator
> driver so that we list the appropriate set of supported voltages
> on these types of regulators.
> 
> Cc: Andy Gross <andy.gross at linaro.org>
> Cc: Bjorn Andersson <bjorn.andersson at linaro.org>
> Fixes: ee01d0c91ef1 ("regulator: qcom-smd: Add support for PMA8084")
> Signed-off-by: Stephen Boyd <sboyd at codeaurora.org>

<snip>

>  static const struct regulator_desc pma8084_pldo = {
>  	.linear_ranges = (struct regulator_linear_range[]) {
> -		REGULATOR_LINEAR_RANGE(750000,  0,  30, 25000),
> -		REGULATOR_LINEAR_RANGE(1500000, 31, 99, 50000),
> +		REGULATOR_LINEAR_RANGE( 750000,  0,  63, 12500),

It was my understanding that the PMOS ldos only support 25mV and 50mV
incremements.

> +		REGULATOR_LINEAR_RANGE(1550000, 64, 126, 25000),
> +		REGULATOR_LINEAR_RANGE(3100000, 127, 163, 50000),
>  	},
> -	.n_linear_ranges = 2,
> -	.n_voltages = 100,
> +	.n_linear_ranges = 3,
> +	.n_voltages = 164,
>  	.ops = &rpm_smps_ldo_ops,

Regards,

Andy



More information about the linux-arm-kernel mailing list