[PATCH 1/2] tty: amba-pl011: add support for clock frequency setting via dt

[Jorge Ramirez]

On 07/08/2016 07:14 PM, Michael Turquette wrote:
> Quoting Jorge Ramirez-Ortiz (2016-07-08 01:11:06)
>> Allow to specify the clock frequency for any given port via the
>> assigned-clock-rates device tree property.
>>
>> Signed-off-by: Jorge Ramirez-Ortiz <jorge.ramirez-ortiz at linaro.org>
>> Tested-by: Jorge Ramirez-Ortiz <jorge.ramirez-ortiz at linaro.org>
>> ---
>>   drivers/tty/serial/amba-pl011.c | 5 +++++
>>   1 file changed, 5 insertions(+)
>>
>> diff --git a/drivers/tty/serial/amba-pl011.c b/drivers/tty/serial/amba-pl011.c
>> index 1b7331e..51867ab 100644
>> --- a/drivers/tty/serial/amba-pl011.c
>> +++ b/drivers/tty/serial/amba-pl011.c
>> @@ -55,6 +55,7 @@
>>   #include <linux/types.h>
>>   #include <linux/of.h>
>>   #include <linux/of_device.h>
>> +#include <linux/clk/clk-conf.h>
>>   #include <linux/pinctrl/consumer.h>
>>   #include <linux/sizes.h>
>>   #include <linux/io.h>
>> @@ -2472,6 +2473,10 @@ static int pl011_probe(struct amba_device *dev, const struct amba_id *id)
>>          if (IS_ERR(uap->clk))
>>                  return PTR_ERR(uap->clk);
>>   
>> +       ret = of_clk_set_defaults(dev->dev.of_node, false);
> Change looks good to me, but with one question: should this change be
> put into more generic code instead of in this specific driver? For
> instance, we call of_clk_set_defaults from the following files:
>
> drivers/base/platform.c
> drivers/i2c/i2c-core.c
> drivers/spi/spi.c
>
> And Stephen posted a patch to do this for devices on the AMBA bus:
>
> https://patchwork.kernel.org/patch/6501691/
>
> Does Stephen's patch mean that you do not need patch #1?

I did a quick test (replaced my changes with the patch above) and the 
console broke and the BT stack couldn't communicate to the device over 
the uart...I guess something else needs doing on top of Stephen's change.