[RESEND PATCH v2 02/13] drivers: clk: st: Simplify clock binding of STiH4xx platforms

[Michael Turquette]

Quoting Rob Herring (2016-06-19 08:04:58)
> On Thu, Jun 16, 2016 at 11:20:22AM +0200, Gabriel Fernandez wrote:
> > This patch reworks the clock binding to avoid too much detail in DT.
> > Now we have only compatible string per type of clock
> > (remark from Rob https://lkml.org/lkml/2016/5/25/492)
> >
> 
> I have no idea what the clock trees and clock controller in these chips 
> look like, so it's hard to say if the changes here are good. It still 
> looks like things are somewhat fine grained clocks in DT. I'll leave 
> it up to the platform maintainers to decide...

Is this series breaking ABI? If yes, why not do what Maxime did for the
Allwinner/sunxi clocks and just fully convert over to a
one-node-per-clock-controller binding? This one-node-per-clock stuff is
pretty unfortunate, and if we're deprecating platforms (patch #1) then
now might be a good time to re-evaluate the whole thing.

Regards,
Mike

>  
> > Signed-off-by: Gabriel Fernandez <gabriel.fernandez at linaro.org>
> > ---
> >  .../devicetree/bindings/clock/st/st,clkgen-mux.txt |  2 +-
> >  .../devicetree/bindings/clock/st/st,clkgen-pll.txt | 11 ++--
> >  .../devicetree/bindings/clock/st/st,clkgen.txt     |  2 +-
> >  .../devicetree/bindings/clock/st/st,quadfs.txt     |  6 +--
> >  drivers/clk/st/clkgen-fsyn.c                       | 41 ++++++--------
> >  drivers/clk/st/clkgen-mux.c                        | 28 ++++------
> >  drivers/clk/st/clkgen-pll.c                        | 62 ++++++++++------------
> >  7 files changed, 65 insertions(+), 87 deletions(-)
> > 
> > diff --git a/Documentation/devicetree/bindings/clock/st/st,clkgen-mux.txt b/Documentation/devicetree/bindings/clock/st/st,clkgen-mux.txt
> > index 4d277d6..9a46cb1d7 100644
> > --- a/Documentation/devicetree/bindings/clock/st/st,clkgen-mux.txt
> > +++ b/Documentation/devicetree/bindings/clock/st/st,clkgen-mux.txt
> > @@ -10,7 +10,7 @@ This binding uses the common clock binding[1].
> >  Required properties:
> >  
> >  - compatible : shall be:
> > -     "st,stih407-clkgen-a9-mux",     "st,clkgen-mux"
> > +     "st,stih407-clkgen-a9-mux"
> >  
> >  - #clock-cells : from common clock binding; shall be set to 0.
> >  
> > diff --git a/Documentation/devicetree/bindings/clock/st/st,clkgen-pll.txt b/Documentation/devicetree/bindings/clock/st/st,clkgen-pll.txt
> > index c9fd674..be0b043 100644
> > --- a/Documentation/devicetree/bindings/clock/st/st,clkgen-pll.txt
> > +++ b/Documentation/devicetree/bindings/clock/st/st,clkgen-pll.txt
> > @@ -9,11 +9,10 @@ Base address is located to the parent node. See clock binding[2]
> >  Required properties:
> >  
> >  - compatible : shall be:
> > -     "st,stih407-plls-c32-a0",       "st,clkgen-plls-c32"
> > -     "st,stih407-plls-c32-a9",       "st,clkgen-plls-c32"
> > -     "sst,plls-c32-cx_0",            "st,clkgen-plls-c32"
> > -     "sst,plls-c32-cx_1",            "st,clkgen-plls-c32"
> > -     "st,stih418-plls-c28-a9",       "st,clkgen-plls-c32"
> 
> > +     "st,clkgen-pll0"
> > +     "st,clkgen-pll0"
> 
> Repeated. Supposed to be 0 and 1? This seems a bit generic, too.
> 
> > +     "st,stih407-clkgen-plla9"
> > +     "st,stih418-clkgen-plla9"