[PATCH 2/3] ARM: dts: imx6sx: Add UDOO Neo support

[Fabio Estevam]

On Tue, Jul 5, 2016 at 1:04 AM, Andreas Färber <afaerber at suse.de> wrote:

> +/dts-v1/;
> +
> +#include "imx6sx-udoo-neo.dtsi"
> +
> +/ {
> +       model = "UDOO Neo Basic";

This should be something like:

model = "Udoo i.MX6 SoloX UDOO Neo Basic";

> +       compatible = "fsl,imx6sx";

compatible = "udoo,imx6sx-udoo-neo", "fsl,imx6sx";

Then you can also send a separate patch to add udoo to
Documentation/devicetree/bindings/vendor-prefixes.txt.

Same applies to other places in this patch.

> +&fec1 {
> +       pinctrl-names = "default";
> +       pinctrl-0 = <&pinctrl_enet1>;
> +       phy-mode = "rmii";
> +       phy-reset-gpios = <&gpio5 4 GPIO_ACTIVE_HIGH>;

Shouldn't this be GPIO_ACTIVE_LOW instead?