[PATCH 0/3] add support for Allwinner SoCs ADC

[Quentin Schulz]

On 29/06/2016 05:28, Chen-Yu Tsai wrote:
> Hi,
> 
> On Tue, Jun 28, 2016 at 4:45 PM, Quentin Schulz
> <quentin.schulz at free-electrons.com> wrote:
>> The Allwinner SoCs all have an ADC that can also act as a touchscreen controller
>> and a thermal sensor. The first four channels can be used either for the ADC or
>> the touchscreen and the fifth channel is used for the thermal sensor. We
>> currently have a driver for the two latter functions in
>> drivers/input/touchscreen/sun4i-ts.c but we don't have access to the ADC feature
>> at all.
>>
>> This adds initial support for Allwinner SoCs ADC with all features. Yet, the
>> touchscreen is not implemented but will be added later. To switch between
>> touchscreen and ADC modes, you need to poke few bits in registers and
>> (de)activate an interrupt (pen-up).
>> A MFD is provided to let the input driver activate the pen-up interrupt through
>> virtual interrupt, poke few bits via regmap and read data from the ADC driver
>> while both (and iio_hwmon) are probed by the MFD.
> 
> I take it that we are going to replace the original sun4i-ts driver
> with this new mfd one, and various sub device drivers?
> 

Yes, that's the spirit.

[...]

> One thing about iio-hwmon is that it doesn't support hwmon labels.
> Any chance you could improve this, so we see the same names in userspace?

Should be an easy patch: reading datasheet_name from iio_chan_spec of
the iio_channel in iio_hwmon_probe, if none then fall back to current
naming convention.

I don't think it is linked to this serie of patches so I prefer to look
at it later.

Thanks!