[PATCH 12/14] ARM: dts: sun8i-a83t: Add RSB nodes to dtsi

[Chen-Yu Tsai]

Hi,

On Sun, Jan 31, 2016 at 9:21 AM, Vishnu Patekar
<vishnupatekar0510 at gmail.com> wrote:
> This adds support for RSB
> A83T RSB is compatible with A23 rsb.
>
> Signed-off-by: Vishnu Patekar <vishnupatekar0510 at gmail.com>
> ---
>  arch/arm/boot/dts/sun8i-a83t.dtsi | 14 ++++++++++++++
>  1 file changed, 14 insertions(+)
>
> diff --git a/arch/arm/boot/dts/sun8i-a83t.dtsi b/arch/arm/boot/dts/sun8i-a83t.dtsi
> index 11be9e1..8c67c85 100644
> --- a/arch/arm/boot/dts/sun8i-a83t.dtsi
> +++ b/arch/arm/boot/dts/sun8i-a83t.dtsi
> @@ -499,5 +499,19 @@
>                                 allwinner,pull = <SUN4I_PINCTRL_PULL_UP>;
>                         };
>                 };
> +
> +               r_rsb: i2c at 01f03400 {
> +                       compatible = "allwinner,sun8i-a23-rsb";
> +                       reg = <0x01f03400 0x400>;
> +                       interrupts = <GIC_SPI 39 IRQ_TYPE_LEVEL_HIGH>;
> +                       clocks = <&apb0_gates 3>;
> +                       clock-frequency = <3000000>;
> +                       resets = <&apb0_reset 3>;
> +                       pinctrl-names = "default";
> +                       pinctrl-0 = <&r_rsb_pins>;

As mentioned in the previous patch, r_rsb_pins should be included in this patch,
since it is used here. In general, we mostly have them as individual patches, as
they are referenced from board dts files. Here since it's used in the dtsi, you
can just include them.

See commit ed473ebd9c15 ("ARM: dts: sun9i: Add Reduced Serial Bus controller
device node to A80 dtsi") on how I described it.

ChenYu

> +                       status = "disabled";
> +                       #address-cells = <1>;
> +                       #size-cells = <0>;
> +               };
>         };
>  };
> --
> 1.9.1
>