[PATCH v2] ARM: dts: at91: sama5d2 Xplained: add phy address and IRQ for macb0

[Nicolas Ferre]

After 57a38effa598 (net: phy: micrel: disable broadcast for KSZ8081/KSZ8091)
the macb0 interface has difficulties to come back from power saving mode if
address not explicitly set up.
As the micrel phy on the board is actually configured to show up at address 1
we use this explicitly.
Adding the phy node and its real address fixes the issue.

The phy IRQ and associated pinmux node is also added.

Signed-off-by: Nicolas Ferre <nicolas.ferre at atmel.com>
Cc: stable at vger.kernel.org # 4.4+ // manual merge needed
---
v2: - correct typos in commit message
    - add a sentence about the IRQ + pinmux as well
    - add stable tag

 arch/arm/boot/dts/at91-sama5d2_xplained.dts | 12 +++++++++++-
 1 file changed, 11 insertions(+), 1 deletion(-)

diff --git a/arch/arm/boot/dts/at91-sama5d2_xplained.dts b/arch/arm/boot/dts/at91-sama5d2_xplained.dts
index 77ddff036409..e683856c507c 100644
--- a/arch/arm/boot/dts/at91-sama5d2_xplained.dts
+++ b/arch/arm/boot/dts/at91-sama5d2_xplained.dts
@@ -114,9 +114,15 @@
 
 			macb0: ethernet at f8008000 {
 				pinctrl-names = "default";
-				pinctrl-0 = <&pinctrl_macb0_default>;
+				pinctrl-0 = <&pinctrl_macb0_default &pinctrl_macb0_phy_irq>;
 				phy-mode = "rmii";
 				status = "okay";
+
+				ethernet-phy at 1 {
+					reg = <0x1>;
+					interrupt-parent = <&pioA>;
+					interrupts = <73 IRQ_TYPE_LEVEL_LOW>;
+				};
 			};
 
 			pdmic at f8018000 {
@@ -300,6 +306,10 @@
 					bias-disable;
 				};
 
+				pinctrl_macb0_phy_irq: macb0_phy_irq {
+					pinmux = <PIN_PC9__GPIO>;
+				};
+
 				pinctrl_pdmic_default: pdmic_default {
 					pinmux = <PIN_PB26__PDMIC_DAT>,
 						<PIN_PB27__PDMIC_CLK>;
-- 
2.1.3