[RFC PATCH v3] irqchip: Add support for Tango interrupt controller

[Måns Rullgård]

Mark Rutland <mark.rutland at arm.com> writes:

> On Wed, Jan 20, 2016 at 05:24:14PM +0100, Marc Gonzalez wrote:
>> On 20/01/2016 17:10, Måns Rullgård wrote:
>> 
>> > Marc Zyngier wrote:
>> > 
>> >>> +	if (of_property_read_u32(node, "reg", &ctl))
>> >>> +		panic("%s: failed to get reg base", node->name);
>> >>> +
>> >>> +	chip = kzalloc(sizeof(*chip), GFP_KERNEL);
>> >>> +	chip->ctl = ctl;
>> >>> +	chip->base = base;
>> > 
>> > As I said before, this assumes the outer DT node uses a ranges
>> > property.  Normally reg properties work the same whether they specify an
>> > offset within an outer "ranges" or have a full address directly.  It
>> > would be easy enough to make this work with either, so I don't see any
>> > reason not to.
>> 
>> IIRC, I was told very early in the review process that the ranges prop
>> was mandatory. Lemme look for it... It was Arnd:
>> 
>> http://thread.gmane.org/gmane.linux.ports.arm.kernel/444131/focus=444207
>
> I believe Arnd's point was that you need _a_ ranges property, rather
> than specifically requiring an idmap/empty ranges property.
>
> As Marc pointed out, you can use of_iomap on the child nodes to map the
> portions described by the reg properties, which will handle any
> ranges-based translation automatically.

No, that's going to get ugly because the generic irqchip needs a single
base address and some of the registers are shared (not part of the range
specified in the child nodes).

-- 
Måns Rullgård