[PATCH 4/4] net: mvneta: update clocks property and document additional clock-names

[Thomas Petazzoni]

Dear Jisheng Zhang,

On Wed, 20 Jan 2016 16:06:23 +0800, Jisheng Zhang wrote:

> diff --git a/Documentation/devicetree/bindings/net/marvell-armada-370-neta.txt b/Documentation/devicetree/bindings/net/marvell-armada-370-neta.txt
> index aeea50c..f85b93b 100644
> --- a/Documentation/devicetree/bindings/net/marvell-armada-370-neta.txt
> +++ b/Documentation/devicetree/bindings/net/marvell-armada-370-neta.txt
> @@ -6,12 +6,16 @@ Required properties:
>  - interrupts: interrupt for the device
>  - phy: See ethernet.txt file in the same directory.
>  - phy-mode: See ethernet.txt file in the same directory
> -- clocks: a pointer to the reference clock for this device.
> +- clocks: Array of clocks required for this device; requires at least one
> +  for CORE clock.

Rather than "Array", I would say "list", so what about:

 - clocks: List of clocks for this device. At least one clock is
   mandatory for the core clock. If several clocks are given, then the
   clock-names property must be used to identify them.

>  Optional properties:
>  - tx-csum-limit: maximum mtu supported by port that allow TX checksum.
>    Value is presented in bytes. If not used, by default 1600B is set for
>    "marvell,armada-370-neta" and 9800B for others.
> +- clock-names: Array of names corresponding to clocks property; shall be
> +  "core" for CORE clock and "axi" for optional AXI clock.

Array -> List.

Thanks!

Thomas
-- 
Thomas Petazzoni, CTO, Free Electrons
Embedded Linux, Kernel and Android engineering
http://free-electrons.com