[PATCH v4 1/1] ARM: perf: Set ARMv7 SDER SUNIDEN bit

[Will Deacon]

On Wed, Jan 13, 2016 at 11:36:26PM -0500, George G. Davis wrote:
> From: Martin Fuzzey <mfuzzey at parkeon.com>
> 
> ARMv7 counters other than the CPU cycle counter only work if the Secure
> Debug Enable Register (SDER) SUNIDEN bit is set.
> 
> Since access to the SDER is only possible in secure state, it will
> only be done if the device tree property "secure-reg-access" is set.
> 
> Without this:
> # perf stat -e cycles,instructions sleep 1
> 
>  Performance counter stats for 'sleep 1':
> 
>           14606094 cycles                    #    0.000 GHz
>                  0 instructions              #    0.00  insns per cycle
> 
> After applying:
> # perf stat -e cycles,instructions sleep 1
> 
>  Performance counter stats for 'sleep 1':
> 
>            5843809 cycles
>            2566484 instructions              #    0.44  insns per cycle
> 
>        1.020144000 seconds time elapsed
> 
> Some platforms (eg i.MX53) may also need additional platform specific
> setup.
> 
> Signed-off-by: Martin Fuzzey <mfuzzey at parkeon.com>
> Signed-off-by: Pooya Keshavarzi <Pooya.Keshavarzi at de.bosch.com>
> Signed-off-by: George G. Davis <george_davis at mentor.com>
> ---
> Changes in v4:
> - Reword commit message to clarify that this change is ARMv7 specific.
> - Clarify that secure-reg-access property is only valid for ARMv7 CPUs
>   and is not supported on anything else (in particular, the arm64
>   port requires you to boot in non-secure mode).
> - Convert on_each_cpu(armv7pmu_enable_secure_access, NULL, 1) call in
>   armv7pmu_init() to in-lined code in ->reset callback, since that is
>   called off the back of a CPU hotplug notifier when the PMU may need
>   to be reinitialised.

Thanks. I'll queue this for 4.6 along with Rob's ack.

Will