[PATCH v2 1/2] regulator: act8945a: add regulator driver for ACT8945A

[Lee Jones]

On Thu, 14 Jan 2016, Yang, Wenyou wrote:

> > -----Original Message-----
> > From: Peter Korsgaard [mailto:jacmet at gmail.com] On Behalf Of Peter Korsgaard
> > Sent: 2016年1月13日 22:22
> > To: Yang, Wenyou <Wenyou.Yang at atmel.com>
> > Cc: Liam Girdwood <lgirdwood at gmail.com>; Mark Brown <broonie at kernel.org>;
> > Rob Herring <robh+dt at kernel.org>; Pawel Moll <pawel.moll at arm.com>; Mark
> > Rutland <mark.rutland at arm.com>; Ian Campbell <ijc+devicetree at hellion.org.uk>;
> > Kumar Gala <galak at codeaurora.org>; Krzysztof Kozlowski
> > <k.kozlowski at samsung.com>; devicetree at vger.kernel.org; Ferre, Nicolas
> > <Nicolas.FERRE at atmel.com>; linux-kernel at vger.kernel.org; Javier Martinez
> > Canillas <javier at dowhile0.org>; Lee Jones <lee.jones at linaro.org>; linux-arm-
> > kernel at lists.infradead.org
> > Subject: Re: [PATCH v2 1/2] regulator: act8945a: add regulator driver for
> > ACT8945A
> > 
> > >>>>> "Wenyou" == Wenyou Yang <wenyou.yang at atmel.com> writes:
> > 
> >  > This patch adds new regulator driver to support ACT8945A MFD  > chip's
> > regulators.
> > 
> >  > The ACT8945A has three step-down DC/DC converters and four  > low-dropout
> > regulators.
> > 
> >  > Signed-off-by: Wenyou Yang <wenyou.yang at atmel.com>
> > 
> > Isn't the regulator part of the act8945a identical to act8865? Can't we just use the
> > existing act8865-regulator.c driver? (E.G. support 8865 variant in the mfd driver,
> > but only register the regulator sub device?)
> 
> Yes, the regulator part of the act8945a is identical to act8865.
> 
> But the act8865-regulator driver is a struct i2c_driver,  and the mfd sub-device driver is a platform_driver driver, it is not easy to use it.

Take a look at some existing files with the pattern
drivers/mfd/*{spi,i2c,core}.c to see how this might be possible.

-- 
Lee Jones
Linaro STMicroelectronics Landing Team Lead
Linaro.org │ Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog