[PATCHv2] clk: ti: omap3+: dpll: use non-locking version of clk_get_rate

[Tero Kristo]

As the code in this file is being executed within irq context in some
cases, we must avoid the clk_get_rate which uses mutex internally.
Switch the code to use clk_hw_get_rate instead which is non-locking.

This fixes an issue where PM runtime will hang the system if enabled
with a serial console before a suspend-resume cycle.

Signed-off-by: Tero Kristo <t-kristo at ti.com>
---
v2: updated commit desc slightly. This patch is still needed as it
    should go in as an -rc fix

 drivers/clk/ti/dpll3xxx.c |    3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/drivers/clk/ti/dpll3xxx.c b/drivers/clk/ti/dpll3xxx.c
index 1c30038..cc73929 100644
--- a/drivers/clk/ti/dpll3xxx.c
+++ b/drivers/clk/ti/dpll3xxx.c
@@ -460,7 +460,8 @@ int omap3_noncore_dpll_enable(struct clk_hw *hw)
 
 	parent = clk_hw_get_parent(hw);
 
-	if (clk_hw_get_rate(hw) == clk_get_rate(dd->clk_bypass)) {
+	if (clk_hw_get_rate(hw) ==
+	    clk_hw_get_rate(__clk_get_hw(dd->clk_bypass))) {
 		WARN_ON(parent != __clk_get_hw(dd->clk_bypass));
 		r = _omap3_noncore_dpll_bypass(clk);
 	} else {
-- 
1.7.9.5