A gic problem about eoi

[Yang Yingliang]

On 2016/2/18 17:00, Marc Zyngier wrote:
> On Thu, 18 Feb 2016 13:00:58 +0800
> Yang Yingliang <yangyingliang at huawei.com> wrote:
>
> Hi Yang,
>
>> Hi, Marc
>>
>> We found if hardware clear pending and active status is slower than
>> software handling, the new sgi will be merged because of hardware
>> status. The new sgi will be lost.
>>
>> If we add a dsb instruction after gic_write_eoir(), it can avoid this
>> case happening.
>>
>> Is it a right way to add a dsb instruction after gic_write_eoir()
>> in current gic driver code ?
>
> I suspect your problem is not so much the EOI, but that the read of
> ICC_IAR1_EL1 doesn't propagate the Ack quickly enough, leading to the
> transition from pending to active to still be in flux when the interrupt
> is EOIed. This is where a DSB is required (and was missing until very
> recently).
>
> Does 1a1ebd5 ("irqchip/gic-v3: Make sure read from ICC_IAR1_EL1 is
> visible on redestributor") solve your problem?

I tested this patch, it can solve the problem.

Will this patch queue to stable ?