[PATCH v3 5/6] dts: ipq4019: Add support for IPQ4019 DK01 board

[Stephen Boyd]

On 02/16, Matthew McClintock wrote:
> On Feb 8, 2016, at 4:43 PM, Stephen Boyd <sboyd at codeaurora.org> wrote:
> > 
> > On 11/19, Matthew McClintock wrote:
> >> +
> >> +/ {
> >> +	model = "Qualcomm Technologies, Inc. IPQ4019/AP-DK01.1";
> >> +	compatible = "qcom,ipq4019";
> >> +
> >> +	clocks {
> >> +                xo: xo {
> >> +                        compatible = "fixed-clock";
> >> +                        clock-frequency = <48000000>;
> >> +                        #clock-cells = <0>;
> >> +                };
> >> +	};
> > 
> > Is there a reason the xo is here and the sleep clk is in the SoC
> > dtsi file? Both are board clocks so I would think they would be
> > added in the same place.
> 
> I’m a little bit confused and I wanted to confirm. I can see the xo clock is on the board itself. However, the sleep_clk is not, can you clarify why they would both be in the same place?
> 

The sleep clk is typically a pin on the SoC package. Look at your
schematic. Same goes for the XO.

-- 
Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum,
a Linux Foundation Collaborative Project