[PATCH v2 1/3] hwmon: Define binding for the nsa320-hwmon driver

[Guenter Roeck]

On 02/15/2016 03:25 PM, Adam Baker wrote:
> Define a binding for the hardware monitoring chip present in the Zyxel
> NSA-320 and some of the other Zyxel NAS devices.
>
> Signed-off-by: Adam Baker <linux at baker-net.org.uk>

Rob sent you an Ack for this patch. Since you did not change the patch
since v1, I would expect to see it here (instead of having to look it up).

Thanks,
Guenter

> ---
>   .../devicetree/bindings/hwmon/nsa320-mcu.txt        | 21 +++++++++++++++++++++
>   1 file changed, 21 insertions(+)
>   create mode 100644 Documentation/devicetree/bindings/hwmon/nsa320-mcu.txt
>
> diff --git a/Documentation/devicetree/bindings/hwmon/nsa320-mcu.txt b/Documentation/devicetree/bindings/hwmon/nsa320-mcu.txt
> new file mode 100644
> index 0000000..7b346d4
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/hwmon/nsa320-mcu.txt
> @@ -0,0 +1,21 @@
> +Bindings for the fan / temperature monitor microcontroller used on
> +the Zyxel NSA 320 and several subsequent models.
> +
> +Required properties:
> +- compatible	: "zyxel,nsa320-mcu"
> +- data-gpios	: The GPIO pin connected to the data line on the MCU
> +- clk-gpios	: The GPIO pin connected to the clock line on the MCU
> +- act-gpios	: The GPIO pin connected to the active line on the MCU
> +
> +Example:
> +
> +	hwmon {
> +		compatible = "zyxel,nsa320-mcu";
> +		pinctrl-0 = <&pmx_mcu_data &pmx_mcu_clk &pmx_mcu_act>;
> +		pinctrl-names = "default";
> +
> +		data-gpios = <&gpio0 14 GPIO_ACTIVE_HIGH>;
> +		clk-gpios = <&gpio0 16 GPIO_ACTIVE_HIGH>;
> +		act-gpios = <&gpio0 17 GPIO_ACTIVE_LOW>;
> +	};
> +
>