[PATCH 4/4] ARM: remove asm/gpio.h

[Russell King - ARM Linux]

On Mon, Feb 15, 2016 at 04:46:31PM +0100, Arnd Bergmann wrote:
> -#if CONFIG_ARCH_NR_GPIO > 0
> -#define ARCH_NR_GPIOS CONFIG_ARCH_NR_GPIO
> -#endif
...
> diff --git a/include/asm-generic/gpio.h b/include/asm-generic/gpio.h
> index 40ec1433f05d..2d04b321db13 100644
> --- a/include/asm-generic/gpio.h
> +++ b/include/asm-generic/gpio.h
> @@ -26,8 +26,12 @@
>   */
>  
>  #ifndef ARCH_NR_GPIOS
> +#ifdef CONFIG_ARCH_NR_GPIO
> +#define ARCH_NR_GPIOS CONFIG_ARCH_NR_GPIO
> +#else
>  #define ARCH_NR_GPIOS		512
>  #endif
> +#endif

This really isn't the same thing, especially when you look at:

config ARCH_NR_GPIO
        int
        default 1024 if ARCH_BRCMSTB || ARCH_SHMOBILE || ARCH_TEGRA || \
                ARCH_ZYNQ
        default 512 if ARCH_EXYNOS || ARCH_KEYSTONE || SOC_OMAP5 || \
                SOC_DRA7XX || ARCH_S3C24XX || ARCH_S3C64XX || ARCH_S5PV210
        default 416 if ARCH_SUNXI
        default 392 if ARCH_U8500
        default 352 if ARCH_VT8500
        default 288 if ARCH_ROCKCHIP
        default 264 if MACH_H4700
        default 0

This has the effect of causing anything not mentioned above to end up
with ARCH_NR_GPIOS set to zero.

You really should _not_ be making these kinds of functional changes
when moving code around.  Separate the two changes: either first move
the code, and have a separate patch to make the functional changes, or
make the functional changes first, and then move the code around.

I'd have thought you would've known this by now...

-- 
RMK's Patch system: http://www.arm.linux.org.uk/developer/patches/
FTTC broadband for 0.8mile line: currently at 9.6Mbps down 400kbps up
according to speedtest.net.