[PATCH v2 5/5] pinctrl: sunxi: Use pin number when calling sunxi_pmx_set

[Linus Walleij]

On Tue, Feb 2, 2016 at 10:21 PM, Krzysztof Adamski <k at japko.eu> wrote:

> sunxi_pmx_set accepts pin number and then calculates offset by
> subtracting pin_base from it. sunxi_pinctrl_gpio_get, on the other hand,
> gets offset so we have to convert it to pin number so we won't get
> negative value in sunxi_pmx_set.
>
> This was only used on A10 so far, where there is only one GPIO chip with
> pin_base set to 0 so it didn't matter. However H3 also requires this
> workaround but have two pinmux sections, triggering problem for PL port.
>
> Signed-off-by: Krzysztof Adamski <k at japko.eu>

Waiting for Maxime to review this. I guess this patch can be merged
independently of the other patches?

Yours,
Linus Walleij