[RFC PATCH v2 2/3] PCI: hisi: Make the HiSilicon PCIe host controller ECAM compliant

[Gabriele Paoloni]

> -----Original Message-----
> From: Arnd Bergmann [mailto:arnd at arndb.de]
> Sent: 08 February 2016 13:48
> To: linux-arm-kernel at lists.infradead.org
> Cc: Gabriele Paoloni; Guohanjun (Hanjun Guo); Wangzhou (B); liudongdong
> (C); Linuxarm; qiujiang; bhelgaas at google.com;
> Lorenzo.Pieralisi at arm.com; tn at semihalf.com; linux-pci at vger.kernel.org;
> linux-kernel at vger.kernel.org; xuwei (O); linux-acpi at vger.kernel.org;
> jcm at redhat.com; zhangjukuo; Liguozhu (Kenneth)
> Subject: Re: [RFC PATCH v2 2/3] PCI: hisi: Make the HiSilicon PCIe host
> controller ECAM compliant
> 
> On Monday 08 February 2016 12:41:03 Gabriele Paoloni wrote:
> > From: gabriele paoloni <gabriele.paoloni at huawei.com>
> >
> > This patch modifies the current Hip05/Hip06 PCIe host controller
> > driver to make it ECAM compliant. This is needed in preparation
> > for the ACPI based driver to allow both DT and ACPI drivers to
> > use the same BIOS (that configure the Designware iATUs).
> >
> > Signed-off-by: Gabriele Paoloni <gabriele.paoloni at huawei.com>
> > Signed-off-by: Dongdong Liu <liudongdong3 at huawei.com>
> >
> 
> Doesn't this break backwards compatibility?

Well Hip05/Hip06 SoCs are used into evaluation boards
For the Estuary project.

https://github.com/hisilicon/estuary

As this new driver gets upstream we'll merge this new driver into estuary
and release a new version of the firmware to support it.

> 
> I think you need to use a new compatible string in the firmware
> if you change the register layout, and then change the driver
> to support both the old and the new layout.

You are right, for some reason in this patchset I missed the Documentation
update that I posted in the previous one, i.e.:

--- a/Documentation/devicetree/bindings/pci/hisilicon-pcie.txt
+++ b/Documentation/devicetree/bindings/pci/hisilicon-pcie.txt
@@ -23,8 +23,8 @@ Optional properties:
 Hip05 Example (note that Hip06 is the same except compatible):
 	pcie at 0xb0080000 {
 		compatible = "hisilicon,hip05-pcie", "snps,dw-pcie";
-		reg = <0 0xb0080000 0 0x10000>, <0x220 0x00000000 0 0x2000>;
-		reg-names = "rc_dbi", "config";
+		reg = <0 0xb0080000 0 0x10000>, <0x220 0x00100000 0 0x0f00000>;
+		reg-names = "rc_dbi", "ecam-cfg";

I will fix this in v3

Thanks

Gab 


> 
> 	Arnd