[PATCH 4/4] video: ARM CLCD: add support of an optional GPIO to enable panel
Linus Walleij
linus.walleij at linaro.org
Fri Dec 30 00:20:53 PST 2016
On Wed, Dec 21, 2016 at 4:27 AM, Vladimir Zapolskiy <vz at mleia.com> wrote:
> The change adds handling of "enable-gpios" property of panel-dpi device
> node used with an ARM CLCD controller, note that the property already has
> a description in display/panel/panel-dpi.txt documentation and it founds
> practical usage while describing some panel devices connected to other
> types of display controllers.
>
> Signed-off-by: Vladimir Zapolskiy <vz at mleia.com>
So as you may have seen I already handle a RESET GPIO in the
Nomadik TPG110 panel subddriver in
drivers/video/fbdev/amba-clcd-nomadik.c
So is this all your panel needs?
I guess it is OK for simple panels.
Yours,
Linus Walleij
More information about the linux-arm-kernel
mailing list