[PATCHv2 net-next 01/11] net: mvpp2: handle too large value handling in mvpp2_rx_pkts_coal_set()
Thomas Petazzoni
thomas.petazzoni at free-electrons.com
Wed Dec 28 08:45:57 PST 2016
Currently, mvpp2_rx_pkts_coal_set() does the following to avoid setting
a too large value for the RX coalescing by packet number:
val = (pkts & MVPP2_OCCUPIED_THRESH_MASK);
This means that if you set a value that is slightly higher the the
maximum number of packets, you in fact get a very low value. It makes a
lot more sense to simply check if the value is too high, and if it's too
high, limit it to the maximum possible value.
Signed-off-by: Thomas Petazzoni <thomas.petazzoni at free-electrons.com>
---
drivers/net/ethernet/marvell/mvpp2.c | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)
diff --git a/drivers/net/ethernet/marvell/mvpp2.c b/drivers/net/ethernet/marvell/mvpp2.c
index 4fe430c..02d91e4 100644
--- a/drivers/net/ethernet/marvell/mvpp2.c
+++ b/drivers/net/ethernet/marvell/mvpp2.c
@@ -4381,11 +4381,11 @@ static void mvpp2_txp_max_tx_size_set(struct mvpp2_port *port)
static void mvpp2_rx_pkts_coal_set(struct mvpp2_port *port,
struct mvpp2_rx_queue *rxq, u32 pkts)
{
- u32 val;
+ if (pkts > MVPP2_OCCUPIED_THRESH_MASK)
+ pkts = MVPP2_OCCUPIED_THRESH_MASK;
- val = (pkts & MVPP2_OCCUPIED_THRESH_MASK);
mvpp2_write(port->priv, MVPP2_RXQ_NUM_REG, rxq->id);
- mvpp2_write(port->priv, MVPP2_RXQ_THRESH_REG, val);
+ mvpp2_write(port->priv, MVPP2_RXQ_THRESH_REG, pkts);
rxq->pkts_coal = pkts;
}
--
2.7.4
More information about the linux-arm-kernel
mailing list