[PATCH v2 01/11] net: mvpp2: handle too large value handling in mvpp2_rx_pkts_coal_set()

Thomas Petazzoni thomas.petazzoni at free-electrons.com
Tue Dec 27 08:54:10 PST 2016


Currently, mvpp2_rx_pkts_coal_set() does the following to avoid setting
a too large value for the RX coalescing by packet number:

  val = (pkts & MVPP2_OCCUPIED_THRESH_MASK);

This means that if you set a value that is slightly higher the the
maximum number of packets, you in fact get a very low value. It makes a
lot more sense to simply check if the value is too high, and if it's too
high, limit it to the maximum possible value.

Signed-off-by: Thomas Petazzoni <thomas.petazzoni at free-electrons.com>
---
 drivers/net/ethernet/marvell/mvpp2.c | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/net/ethernet/marvell/mvpp2.c b/drivers/net/ethernet/marvell/mvpp2.c
index 4fe430c..02d91e4 100644
--- a/drivers/net/ethernet/marvell/mvpp2.c
+++ b/drivers/net/ethernet/marvell/mvpp2.c
@@ -4381,11 +4381,11 @@ static void mvpp2_txp_max_tx_size_set(struct mvpp2_port *port)
 static void mvpp2_rx_pkts_coal_set(struct mvpp2_port *port,
 				   struct mvpp2_rx_queue *rxq, u32 pkts)
 {
-	u32 val;
+	if (pkts > MVPP2_OCCUPIED_THRESH_MASK)
+		pkts = MVPP2_OCCUPIED_THRESH_MASK;
 
-	val = (pkts & MVPP2_OCCUPIED_THRESH_MASK);
 	mvpp2_write(port->priv, MVPP2_RXQ_NUM_REG, rxq->id);
-	mvpp2_write(port->priv, MVPP2_RXQ_THRESH_REG, val);
+	mvpp2_write(port->priv, MVPP2_RXQ_THRESH_REG, pkts);
 
 	rxq->pkts_coal = pkts;
 }
-- 
2.7.4




More information about the linux-arm-kernel mailing list