[PATCH v4 06/12] dt: bindings: Add bindings for Marvell Xenon SD Host Controller

[Russell King - ARM Linux]

On Tue, Dec 13, 2016 at 06:48:35PM +0100, Gregory CLEMENT wrote:
> +Optional Properties:
> +- mmc-card:
> +  mmc-card child node must be provided when current SDHC is for eMMC.
> +  Xenon SDHC often can support both SD and eMMC. This child node indicates that
> +  current SDHC is for eMMC card. Thus Xenon eMMC specific configuration and
> +  operations can be enabled prior to eMMC init sequence.
> +  Please refer to Documentation/devicetree/bindings/mmc/mmc-card.txt.
> +  This child node should not be set if current Xenon SDHC is for SD/SDIO.

This looks like a typo - shouldn't it be "mmccard" and not "mmc-card"?
Your examples below use "mmccard" as does the documentation you point
towards.

-- 
RMK's Patch system: http://www.armlinux.org.uk/developer/patches/
FTTC broadband for 0.8mile line: currently at 9.6Mbps down 400kbps up
according to speedtest.net.