[PATCH 2/5] arm: mvebu: support for SMP on 98DX3336 SoC
Chris Packham
chris.packham at alliedtelesis.co.nz
Wed Dec 21 20:13:25 PST 2016
Compared to the armada-xp the 98DX3336 uses different registers to set
the boot address for the secondary CPU so a new enable-method is needed.
This will only work if the machine definition doesn't define an overall
smp_ops because there is not currently a way of overriding this from the
device tree if it is set in the machine definition.
Signed-off-by: Chris Packham <chris.packham at alliedtelesis.co.nz>
---
.../bindings/arm/marvell/98dx3236-resume-ctrl.txt | 18 ++++++
arch/arm/mach-mvebu/Makefile | 1 +
arch/arm/mach-mvebu/common.h | 1 +
arch/arm/mach-mvebu/platsmp.c | 43 ++++++++++++++
arch/arm/mach-mvebu/pmsu-98dx3236.c | 69 ++++++++++++++++++++++
5 files changed, 132 insertions(+)
create mode 100644 Documentation/devicetree/bindings/arm/marvell/98dx3236-resume-ctrl.txt
create mode 100644 arch/arm/mach-mvebu/pmsu-98dx3236.c
diff --git a/Documentation/devicetree/bindings/arm/marvell/98dx3236-resume-ctrl.txt b/Documentation/devicetree/bindings/arm/marvell/98dx3236-resume-ctrl.txt
new file mode 100644
index 000000000000..8082ba872edd
--- /dev/null
+++ b/Documentation/devicetree/bindings/arm/marvell/98dx3236-resume-ctrl.txt
@@ -0,0 +1,18 @@
+Resume Control
+--------------
+Available on Marvell SOCs: 98DX3336 and 98DX4251
+
+Required properties:
+
+- compatible: must be "marvell,98dx3336-resume-ctrl"
+
+- reg: Should contain resume control registers location and length
+
+Example:
+
+resume at 20980 {
+ compatible = "marvell,98dx3336-resume-ctrl";
+ reg = <0x20980 0x10>;
+};
+
+
diff --git a/arch/arm/mach-mvebu/Makefile b/arch/arm/mach-mvebu/Makefile
index 6c6497e80a7b..2a2dd8324fb8 100644
--- a/arch/arm/mach-mvebu/Makefile
+++ b/arch/arm/mach-mvebu/Makefile
@@ -7,6 +7,7 @@ obj-$(CONFIG_MACH_MVEBU_ANY) += system-controller.o mvebu-soc-id.o
ifeq ($(CONFIG_MACH_MVEBU_V7),y)
obj-y += cpu-reset.o board-v7.o coherency.o coherency_ll.o pmsu.o pmsu_ll.o
+obj-y += pmsu-98dx3236.o
obj-$(CONFIG_PM) += pm.o pm-board.o
obj-$(CONFIG_SMP) += platsmp.o headsmp.o platsmp-a9.o headsmp-a9.o
diff --git a/arch/arm/mach-mvebu/common.h b/arch/arm/mach-mvebu/common.h
index 6b775492cfad..099dabf23461 100644
--- a/arch/arm/mach-mvebu/common.h
+++ b/arch/arm/mach-mvebu/common.h
@@ -27,4 +27,5 @@ void __iomem *mvebu_get_scu_base(void);
int mvebu_pm_suspend_init(void (*board_pm_enter)(void __iomem *sdram_reg,
u32 srcmd));
+void mv98dx3236_resume_set_cpu_boot_addr(int hw_cpu, void *boot_addr);
#endif
diff --git a/arch/arm/mach-mvebu/platsmp.c b/arch/arm/mach-mvebu/platsmp.c
index 46c742d3bd41..3c9ab9a008ad 100644
--- a/arch/arm/mach-mvebu/platsmp.c
+++ b/arch/arm/mach-mvebu/platsmp.c
@@ -182,5 +182,48 @@ const struct smp_operations armada_xp_smp_ops __initconst = {
#endif
};
+static int mv98dx3236_boot_secondary(unsigned int cpu, struct task_struct *idle)
+{
+ int ret, hw_cpu;
+
+ pr_info("Booting CPU %d\n", cpu);
+
+ hw_cpu = cpu_logical_map(cpu);
+ set_secondary_cpu_clock(hw_cpu);
+ mv98dx3236_resume_set_cpu_boot_addr(hw_cpu,
+ armada_xp_secondary_startup);
+
+ /*
+ * This is needed to wake up CPUs in the offline state after
+ * using CPU hotplug.
+ */
+ arch_send_wakeup_ipi_mask(cpumask_of(cpu));
+
+ /*
+ * This is needed to take secondary CPUs out of reset on the
+ * initial boot.
+ */
+ ret = mvebu_cpu_reset_deassert(hw_cpu);
+ if (ret) {
+ pr_warn("unable to boot CPU: %d\n", ret);
+ return ret;
+ }
+
+ return 0;
+}
+
+struct smp_operations mv98dx3236_smp_ops __initdata = {
+ .smp_init_cpus = armada_xp_smp_init_cpus,
+ .smp_prepare_cpus = armada_xp_smp_prepare_cpus,
+ .smp_boot_secondary = mv98dx3236_boot_secondary,
+ .smp_secondary_init = armada_xp_secondary_init,
+#ifdef CONFIG_HOTPLUG_CPU
+ .cpu_die = armada_xp_cpu_die,
+ .cpu_kill = armada_xp_cpu_kill,
+#endif
+};
+
CPU_METHOD_OF_DECLARE(armada_xp_smp, "marvell,armada-xp-smp",
&armada_xp_smp_ops);
+CPU_METHOD_OF_DECLARE(mv98dx3236_smp, "marvell,98dx3236-smp",
+ &mv98dx3236_smp_ops);
diff --git a/arch/arm/mach-mvebu/pmsu-98dx3236.c b/arch/arm/mach-mvebu/pmsu-98dx3236.c
new file mode 100644
index 000000000000..fadc81d0c051
--- /dev/null
+++ b/arch/arm/mach-mvebu/pmsu-98dx3236.c
@@ -0,0 +1,69 @@
+/**
+ * CPU resume support for 98DX4521 internal CPU (a.k.a. MSYS).
+ */
+
+#define pr_fmt(fmt) "mv98dx3236-resume: " fmt
+
+#include <linux/kernel.h>
+#include <linux/init.h>
+#include <linux/of_address.h>
+#include <linux/io.h>
+#include "common.h"
+
+static void __iomem *mv98dx3236_resume_base;
+#define MV98DX3236_CPU_RESUME_CTRL_OFFSET 0x08
+#define MV98DX3236_CPU_RESUME_ADDR_OFFSET 0x04
+
+static const struct of_device_id of_mv98dx3236_resume_table[] = {
+ {.compatible = "marvell,98dx3336-resume-ctrl",},
+ { /* end of list */ },
+};
+
+void mv98dx3236_resume_set_cpu_boot_addr(int hw_cpu, void *boot_addr)
+{
+ WARN_ON(hw_cpu != 1);
+
+ writel(0, mv98dx3236_resume_base + MV98DX3236_CPU_RESUME_CTRL_OFFSET);
+ writel(virt_to_phys(boot_addr), mv98dx3236_resume_base +
+ MV98DX3236_CPU_RESUME_ADDR_OFFSET);
+}
+
+static int __init mv98dx3236_resume_init(void)
+{
+ struct device_node *np;
+ struct resource res;
+ int ret = 0;
+
+ np = of_find_matching_node(NULL, of_mv98dx3236_resume_table);
+ if (!np)
+ return 0;
+
+ pr_info("Initializing 98DX4521 Resume\n");
+
+ if (of_address_to_resource(np, 0, &res)) {
+ pr_err("unable to get resource\n");
+ ret = -ENOENT;
+ goto out;
+ }
+
+ if (!request_mem_region(res.start, resource_size(&res),
+ np->full_name)) {
+ pr_err("unable to request region\n");
+ ret = -EBUSY;
+ goto out;
+ }
+
+ mv98dx3236_resume_base = ioremap(res.start, resource_size(&res));
+ if (!mv98dx3236_resume_base) {
+ pr_err("unable to map registers\n");
+ release_mem_region(res.start, resource_size(&res));
+ ret = -ENOMEM;
+ goto out;
+ }
+
+out:
+ of_node_put(np);
+ return ret;
+}
+
+early_initcall(mv98dx3236_resume_init);
--
2.11.0.24.ge6920cf
More information about the linux-arm-kernel
mailing list