[v4, 3/3] ARM: dts: vf610-zii-dev-rev-b: Remove 'fixed-link' from DSA ports

[Uwe Kleine-König]

On Wed, Dec 21, 2016 at 03:58:45PM +0300, Nikita Yushchenko wrote:
> > Remove 'fixed-link' nodes from DSA ports since they are not needed (they
> > are not limiting link's speed and the ports will be configured to their
> > maximux speed as a default)
> >
> > Suggested-by: Andrew Lunn <andrew at lunn.ch>
> > Signed-off-by: Andrey Smirnov <andrew.smirnov at gmail.com>
> 
> With this patch, ports connected to revB's second switch stop working.

This is probably because without a fixed-link node the phy-mode setting
isn't applied by the driver.

Best regards
Uwe

-- 
Pengutronix e.K.                           | Uwe Kleine-König            |
Industrial Linux Solutions                 | http://www.pengutronix.de/  |