[PATCH v3 net-next 3/3] arm64: dts: marvell: Add ethernet switch definition for the ESPRESSObin
Romain Perier
romain.perier at free-electrons.com
Wed Dec 21 01:00:45 PST 2016
This defines and enables the Marvell ethernet switch MVE886341 on the
Marvell ESPRESSObin board.
Signed-off-by: Romain Perier <romain.perier at free-electrons.com>
---
Changes in v3:
- Changed the node switch0 to be at 1
- Removed reg=<1> from the mdio node, finally that's not required
Changes in v2:
- EXPRESSObin -> ESPRESSObin
- phy nodes definition must contain the internal bus address after the @
.../boot/dts/marvell/armada-3720-espressobin.dts | 66 ++++++++++++++++++++++
1 file changed, 66 insertions(+)
diff --git a/arch/arm64/boot/dts/marvell/armada-3720-espressobin.dts b/arch/arm64/boot/dts/marvell/armada-3720-espressobin.dts
index 83178d9..12d9f65 100644
--- a/arch/arm64/boot/dts/marvell/armada-3720-espressobin.dts
+++ b/arch/arm64/boot/dts/marvell/armada-3720-espressobin.dts
@@ -80,3 +80,69 @@
&usb3 {
status = "okay";
};
+
+&mdio {
+ switch0: switch0 at 1 {
+ compatible = "marvell,mv88e6085";
+ #address-cells = <1>;
+ #size-cells = <0>;
+ reg = <1>;
+
+ dsa,member = <0 0>;
+
+ ports {
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ port at 0 {
+ reg = <0>;
+ label = "cpu";
+ ethernet = <ð0>;
+ };
+
+ port at 1 {
+ reg = <1>;
+ label = "wan";
+ phy-handle = <&switch0phy0>;
+ };
+
+ port at 2 {
+ reg = <2>;
+ label = "lan0";
+ phy-handle = <&switch0phy1>;
+ };
+
+ port at 3 {
+ reg = <3>;
+ label = "lan1";
+ phy-handle = <&switch0phy2>;
+ };
+
+ };
+
+ mdio {
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ switch0phy0: switch0phy0 at 11 {
+ reg = <0x11>;
+ };
+ switch0phy1: switch0phy1 at 12 {
+ reg = <0x12>;
+ };
+ switch0phy2: switch0phy2 at 13 {
+ reg = <0x13>;
+ };
+ };
+ };
+};
+
+ð0 {
+ phy-mode = "rgmii-id";
+ status = "okay";
+
+ fixed-link {
+ speed = <1000>;
+ full-duplex;
+ };
+};
--
2.9.3
More information about the linux-arm-kernel
mailing list