[PATCH v6 3/8] PWM: add pwm-stm32 DT bindings

[Benjamin Gaignard]

2016-12-13 16:57 GMT+01:00 Rob Herring <robh at kernel.org>:
> On Tue, Dec 13, 2016 at 5:11 AM, Lee Jones <lee.jones at linaro.org> wrote:
>> On Mon, 12 Dec 2016, Rob Herring wrote:
>>
>>> On Fri, Dec 09, 2016 at 03:15:14PM +0100, Benjamin Gaignard wrote:
>>> > Define bindings for pwm-stm32
>>> >
>>> > version 6:
>>> > - change st,breakinput parameter format to make it usuable on stm32f7 too.
>>> >
>>> > version 2:
>>> > - use parameters instead of compatible of handle the hardware configuration
>>> >
>>> > Signed-off-by: Benjamin Gaignard <benjamin.gaignard at st.com>
>>> > ---
>>> >  .../devicetree/bindings/pwm/pwm-stm32.txt          | 33 ++++++++++++++++++++++
>>> >  1 file changed, 33 insertions(+)
>>> >  create mode 100644 Documentation/devicetree/bindings/pwm/pwm-stm32.txt
>>> >
>>> > diff --git a/Documentation/devicetree/bindings/pwm/pwm-stm32.txt b/Documentation/devicetree/bindings/pwm/pwm-stm32.txt
>>> > new file mode 100644
>>> > index 0000000..866f222
>>> > --- /dev/null
>>> > +++ b/Documentation/devicetree/bindings/pwm/pwm-stm32.txt
>>> > @@ -0,0 +1,33 @@
>>> > +STMicroelectronics STM32 Timers PWM bindings
>>> > +
>>> > +Must be a sub-node of an STM32 Timers device tree node.
>>> > +See ../mfd/stm32-timers.txt for details about the parent node.
>>> > +
>>> > +Required parameters:
>>> > +- compatible:              Must be "st,stm32-pwm".
>>> > +- pinctrl-names:   Set to "default".
>>> > +- pinctrl-0:               List of phandles pointing to pin configuration nodes for PWM module.
>>> > +                   For Pinctrl properties see ../pinctrl/pinctrl-bindings.txt
>>> > +
>>> > +Optional parameters:
>>> > +- st,breakinput:   Arrays of three u32 <index level filter> to describe break input configurations.
>>> > +                   "index" indicates on which break input the configuration should be applied.
>>> > +                   "level" gives the active level (0=low or 1=high) for this configuration.
>>> > +                   "filter" gives the filtering value to be applied.
>>> > +
>>> > +Example:
>>> > +   timers at 40010000 {
>>>
>>> timer at ...
>>
>> No, it should be timers.
>
> Read the spec. "timer" is a generic node name. "timers" is not. How
> many is not relevant.

"timer" is already used in stm32 DT for clocksource node... It is also why
I use "timers" for this.

>
>> The 's' is intentional, since this parent (MFD) device houses 3
>> different types of timers.  The "timer" node is a child of this one.



-- 
Benjamin Gaignard

Graphic Study Group

Linaro.org │ Open source software for ARM SoCs

Follow Linaro: Facebook | Twitter | Blog